Electronics Forum | Wed Sep 12 08:22:52 EDT 2001 | pr
Last I heard DEK was coming out with a new Revision of Form Flex to address some of the problems seen on the old revs. You should contact Dek and see if they will replace your old ones with the new rev. When ot works it's a great tool.
Electronics Forum | Tue Nov 20 18:42:03 EST 2018 | sabeti
Hi There, Thanks for your reply. Yes, this is the sensor which is creating the problem currently. The sensor is faulty. Is there any way to bypass the sensor to get the machine running? Thanks
Electronics Forum | Thu Aug 16 11:15:38 EDT 2012 | menatech
delete the pointer readings.dek. If the printer loads after restart is the problem a corrupt program (last printed product. if this not work could it be a problem with the DEK config file. save the the file on floppy and delete it from the m/c. the s
Electronics Forum | Thu Aug 16 07:46:50 EDT 2012 | omur
We have the following problem with our DEK265GS during start-up: Loading Program... Loading Language... Stack Overflow! Any help / pointers would be much appreciated. Omur...
Electronics Forum | Sat Feb 25 11:23:58 EST 2006 | Curt
You may need to re-load the MINT files.
Electronics Forum | Sun Aug 26 15:09:18 EDT 2012 | aelektronik
Did you try running an AV scan on your files.
Electronics Forum | Fri Feb 24 20:05:31 EST 2006 | Robert
I had a problem to calibrate the vision of the DEK 265LT machine. After touch the calibration vision button a error message come up "Unable to load file CALIBRA.PR1" Does anyone know what fault could cause this? Do i need a calibration program? Doe
Electronics Forum | Mon Jul 30 01:14:37 EDT 2018 | erici
Our DEK 265LT wont boot up with the DEK software. It says that the current version of the software can only run a 265GS printer, and to install the correct release of the software. Has anybody encountered the same problem? It just started happenin
Electronics Forum | Thu Aug 02 16:47:37 EDT 2018 | erici
Thanks for all your help guys. The problem ended up with the parallel port where the hardware key(dongle) was attached. The cabling from the pc to the parallel port at the back of the machine was defective. Cheers
Electronics Forum | Mon Jul 30 11:05:57 EDT 2018 | dekhead
Failure on PCIB40#3; try swap with PCIB40#5. Will need to change addressing (jumpers or rotary SW).