Electronics Forum | Mon Oct 29 15:58:47 EST 2001 | davef
Kitting: Buy-in material in kit form that is complete and in the proper form. Line set-up: Layout all boards to be the same width. Printer set-up: Use a dispenser, instead of a printer. Dispenser set-up: Program & debug off-line. Placement machin
Electronics Forum | Thu Feb 28 05:21:53 EST 2019 | sarason
Hardware design is a specialized area. It is best to make sure that the person doing the design has experience in each area of your design. If not they are learning at your expense while your product and your business heads down the gurgler. Sometime
Electronics Forum | Thu Aug 15 09:06:59 EDT 2002 | davef
Very short list of strategies: * Accept only products are designed to be manufactured and tested. * Assure components are of the proper form and are solderable. * Make sure your processes are capable and in control. * Provide lots of training for you
Electronics Forum | Thu Dec 05 17:40:24 EST 2002 | davef
While unfamiliar with some of the terms you use, could this be what you seek? http://www.pcbstandards.com/downloads/Metric%20Environment/General%20Documentation/PCB%20Design/PCB%20Design%20Routing/Metric%20BGA%20Routing.pdf Stepping backwards just
Electronics Forum | Thu Aug 25 11:33:32 EDT 2005 | slthomas
I suppose it depends on your layout software. My weak recollection of what PowerPCB does is allow you to set up rules as far as spacing and where parts are placed, then you run the rule check, er something like that. As far as "Also what I"m thinkin
Electronics Forum | Thu Jul 15 09:27:12 EDT 1999 | Erick Russell
Earl, Srt makes a system called the summit 2100D. Its a relatively new product but it is designed for rework applications. The programming is simple and interfaces well with other srt products. As with any dispensing system, you have to clean th
Electronics Forum | Mon Feb 28 06:06:04 EST 2005 | Guest
I'm looking for recommendations on pad and stencil design for products with 0.5 mm pitch BGA's. The latest info that I found in the archives of this forum dated more than a year ago. It didn't give me much confidence that assembly of such components
Electronics Forum | Thu Apr 10 09:29:58 EDT 2008 | realchunks
Umm.... he states he is using the Induium paste for 2 weeks and experiencing problems. The problem percentage drops when he changes lot # of paste. Problem occurs on 3 different lines (assuming 3 different product). What's the common variable on a
Electronics Forum | Tue Jul 25 12:14:39 EDT 2006 | russ
All my studies led me to believe that it was CTE mismatch of this package. Altera was of less than 0 help in this matter. The other possibility was an ICT test fixture. Unfortunately (?) the design life of this product was at end and the new design
Electronics Forum | Thu Jul 26 20:28:52 EDT 2001 | davef
You're correct. Check the fine SMTnet Archives to get started. Look in both the "design" and the "production" conferences.
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400