Electronics Forum | Wed Nov 07 11:09:43 EST 2007 | cyber_wolf
Ya probably most used equipment guys do skip that step on the machines they sell as "production ready" As for us, our machines need to actually build boards without going down on the errors that dirty clutches create....you silly man.
Electronics Forum | Wed Aug 10 04:15:01 EDT 2005 | vinitverma
Ari, I would suggest you make a checklist of all your requirements (not just large scale production) and prioritize them with weights assigned to each. Fill in the checklist for each equipment and manufacturer and you'll have the results out. I wou
Electronics Forum | Sat Feb 17 21:46:26 EST 2001 | edmo
I am the new user for siplace HS50 for about 3 months, running 24 hours production. I used to perform PM every 2 weeks. I have just changed all the plungers(Alu) and nozzles(904) and some nozzle sleeves due to components high throw-out. The estimat
Electronics Forum | Fri Jun 11 11:42:14 EDT 2004 | Claude_Couture
hum, I see no problem for your people supporting any line that can run this speed. If your chip shooters are the dual feeder carriage kind, you must run them in replace mode, when one feeder runs out in one carriage, it parks it and continues running
Electronics Forum | Mon Feb 21 08:44:10 EST 2011 | kahrpr
They all are inlineish They just carry the board to the vapor chamber. in a reflow system all the boards in the oven from beginning to end are in state of process, which gives you more speed. If the board has a long cycle time VP is not a problem. If
Electronics Forum | Tue May 17 16:46:52 EDT 2005 | davef
Most placement machine equipment suppliers offer software for line balancing. What's with Fuji? Fujitrax is a system developed in order to attain high levels of "progress management, quality management & traceability" over several SMT lines, throug
Electronics Forum | Wed May 18 04:12:11 EDT 2005 | Rob
Or you could always buy a stopwatch..... You can then move over components from one machine to the next during your maintenance periods. If you don't build too many products this is going to be quicker than evaluating, installing & learning a new p
Electronics Forum | Sat Aug 17 03:39:13 EDT 2002 | shrikant_borkar
Monitor daily Machine MIS data for parts rejection ofcourse your weekly/monthly preventive maintenance must be regular. following steps- will be helful 1. qulaity output from machine by taking immidiate action over online detected faults. concentrat
Electronics Forum | Sun Jan 19 16:46:34 EST 2003 | CJN
Just to let all know that I accepted a fulltime postion with a very good OEM company and start next week. Thanks for your concern and good luck to everyone else still looking. This company is looking for a few machine maintenance repair guys stro
Electronics Forum | Fri Apr 15 08:42:23 EDT 2022 | sn
Thank you for sharing the helpful information. Let's say the PCB is a double-side assemble process and this PCB has completed the first reflowing SMT assembly process, is there any concern if the board is kept on the production floor with temperatur
winsouce.jpg)
