Electronics Forum | Tue Jun 08 13:06:53 EDT 1999 | Kevin Hussey
| | Hi,my master | | How to iron out such soldering bridge with below conditions: | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | 3.using spraying fl
Electronics Forum | Tue Jun 08 12:49:41 EDT 1999 | Dave F
| Hi,my master | How to iron out such soldering bridge with below conditions: | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | 3.using spraying fluxer and n
Electronics Forum | Tue Jun 08 17:52:53 EDT 1999 | Chrys Shea
| | | Hi,my master | | | How to iron out such soldering bridge with below conditions: | | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | | 3.using s
Electronics Forum | Fri May 07 15:37:22 EDT 1999 | JohnW
| This is not strictly a surface mount query but any input welcome | I am thinking of using surface mount solder thief pads for a through hole connector. The connector is two rows of 0.1" pitch pins and on waving there is often a bridge on the last t
Electronics Forum | Tue Apr 28 04:07:56 EDT 2009 | davepick
There's a nice tool on this site - http://www.enhancetechnical.co.uk/ Click on Internet Tools and then the image - brings up a useful interactive tools which helps understand influences on wave solder bridges. Dave
Electronics Forum | Thu Aug 29 20:01:23 EDT 2002 | davef
Many people use the same spacing [and pad designs] as they use for primary side SMT. We don�t. DOWN STREAM SMT-TO-SMT SPACING: In addition to proper orientation, components cannot be immediately upstream of terminations that are to be soldered or b
Electronics Forum | Fri Jun 07 10:28:23 EDT 2013 | danselness
We use a Wave Solder Plated Through Hole (PTH) assembly process to install a TO-220 Chip Package in the PCB board that we manufacture and have experienced lower yields on a number of boards with this component due to Bridges. The bridges on the TO-22
Electronics Forum | Mon Jun 29 16:03:24 EDT 2020 | spoiltforchoice
I certainly can on the Paraquda and I suspect the basic algorithms are the same. Slimmer annular rings such as you might get on a plated via hole don't always image quite as well but if for some reason it doesn't pick it up you should be able to inte
Electronics Forum | Mon Dec 28 15:43:22 EST 1998 | Mark D.
We have a new PTH board that utilizes lap pads on the B/S. Some of the pads are paired closely together and are aligned at angles (30,45,60 degrees)to the boards direction of travel through the wave. The pads most always bridge together. I realize th
Electronics Forum | Mon Dec 28 19:28:57 EST 1998 | Chad Haima
| We have a new PTH board that utilizes lap pads on the B/S. Some of the pads are paired closely together and are aligned at angles (30,45,60 degrees)to the boards direction of travel through the wave. The pads most always bridge together. I realize
