Electronics Forum | Thu Aug 05 05:23:13 EDT 2004 | Bryan
Hi All,per my understanding ,the fail mode is the heel fillet of QFP seems no good,right?If yes...I think..we should:1.increase the aperture length on stencil and make sure there's enough solder paste on pad before reflow. or you can increase your t
Electronics Forum | Tue Oct 26 03:12:36 EDT 2004 | Joseph
Dear all, Recently our production encountered high SOIC failure during testing after reflow soldering. All solder fillets (side/heel) are acceptable as per IPC standard.The reject samples (SOIC)being sent to IC manufacturer to verify the failure. Fin
Electronics Forum | Thu Sep 19 11:14:45 EDT 2002 | Jim M.
We had lots of problems with bridging on 15.8mm pitch, QFP17-160 at the start.The board was .032 thick, double sided-six boards to a panel. Here is the problems (not neccessarily in the biggest to little but as i remember them) and solutions that he
| 1 |
