Electronics Forum | Fri Sep 24 15:56:45 EDT 1999 | Michael Weekes
We are looking for a midwest board design house - Mike Weekes - 630 595 2300 x292 or email me at mweekes@phoenixofchicago.com
Electronics Forum | Fri Oct 01 09:45:53 EDT 1999 | Andrew W. Dalrymple
| We are looking for a midwest board design house - Mike Weekes - 630 595 2300 x292 or email me at mweekes@phoenixofchicago.com | | I am starting up a PWB Design Service Company. We are Currently in Dallas. My partner and I have 25 years experia
Electronics Forum | Fri Oct 01 15:08:49 EDT 1999 | Dave F
| We are looking for a midwest board design house - Mike Weekes - 630 595 2300 x292 or email me at mweekes@phoenixofchicago.com | | Michael: Try:
Electronics Forum | Mon May 08 20:58:08 EDT 2000 | Dave F
Jay: Can't harly beat the price, eh? Every year or so "Printed Circuit Design" Magazine (www.pcdmag.com ???) bench mark board software. Their benchmarks are on their site. How about using them to evaluated your software? And comparing that ratin
Electronics Forum | Thu Oct 23 08:13:44 EDT 2003 | davef
The SEMA listing [ http://www.smema.org/smema5.pdf ] says: * D CUT SQUEEGEE: A single diamond edge squeegee which is shaped like an upside down house and made of polyurethane. * FOUR-SIDED DIAMOND EDGE SQUEEGEE: A polyurethane 3/8 x 3/8 four sided, f
Electronics Forum | Wed Sep 15 22:01:34 EDT 2004 | rohman23
We've had a few problems with printing a flex-rigid PWB, and I'm hoping some of you could throw some opinions/suggestions my way. Our PWB is about 8" x 11" divided into two parts (side A & B) by 2 wide flex cables. Each of these flex cables is ab
Electronics Forum | Mon Sep 20 06:21:05 EDT 2004 | C Lampron
Hi Chris, Acually, it worked pretty good. We made a new blade from SS. We were not sure if it would work so we diddn't want to commit a good sqeegee blade. You will want to try to keep the cutaway toward the center of the blade. And don't hit the fl
Electronics Forum | Thu Sep 16 07:07:34 EDT 2004 | C Lampron
Hello Chris, "It sticks up about 3/8" or so above the surface of the board." Is this over the ridgid portion of the PCB or in between? Is it possible to create a support fixture for printing that has relief that will allow the flex to bow downward i
Electronics Forum | Thu Sep 16 15:28:06 EDT 2004 | rohman23
Actually, it's not even close to 3/8". It's more like 0.075"...not sure what I was smoking last night (I tried to guess on dimensions from my house, and now I have one in front of me). Anyway, to answer your question, the bulge is in between side A
Electronics Forum | Fri Sep 17 09:31:33 EDT 2004 | C Lampron
Hi Chris, It sounds like you may have to go with your idea of a relief cut into the stencil. Are there any components that need to be printed in close proximity? Is this a high volume?I used to work at a flex house and we had a similar situation. We
