Electronics Forum | Thu Jul 15 16:29:54 EDT 2010 | dilogic
I am trying to locate procedure for PWC calibration/adjustment on GSM1/2 machines (after moving feeder plate), but can't find it in the manuals. I would appreciate if somebody can give me a hint... - Deni
Electronics Forum | Sun Sep 18 06:17:40 EDT 2022 | poly
I'll double check tomorrow but I don't think so, it fails zeroing straight away (without moving the other parts) when the PWC axis is enabled, which is why I tried swapping the board as I assumed it was a controller not being found issue.
Electronics Forum | Thu Sep 02 10:50:21 EDT 2010 | eezday
I'm bringing a GSM-1 machine at a university back to operational condition. I have a project created and I'm experiencing that when it's loaded the PWC goes to a location that is about two inches too narrow. When the PWC is manually told to go to a
Electronics Forum | Fri Feb 19 11:13:02 EST 2016 | ttheis
I'm setting up a product for the first time on my GSM after I completed debugging some other issues. The previous owners had the PWC axis disabled and the axis motor disconnected, so I re-connected it and enabled it and now it homes and moves. When I
Electronics Forum | Tue Sep 06 18:49:16 EDT 2022 | dilogic
Broken/disconnected position encoder?
Electronics Forum | Sun Sep 18 06:07:52 EDT 2022 | dilogic
Does motor start to move during zeroing at all?
Electronics Forum | Fri Feb 19 15:23:31 EST 2016 | ttheis
RESOLVED I adjusted the "Minimum Board Width" in the Board Handling Configuration to resolve this issue. I set the lane width to a larger value which did not hit the front limit and measured the difference between the actual lane width and the set l
Electronics Forum | Tue Sep 06 01:32:25 EDT 2022 | poly
I've got two Genesis machines (GC30 and GX11) that I bought used. The PWC on one is disabled, and if I enable that axis the machine will tell me it can't find or initialise that axis. I tried swapping the board 48904905 from the working machine to th
Electronics Forum | Mon Feb 10 14:29:01 EST 2014 | dilogic
Sorry, I did not check the forum for a few days. Slot 12 controller is in charge for PWC and Beam1 Head1 (front) theta and Z axes. Which sw. version is installed on your machine?
Electronics Forum | Tue Jun 09 16:29:03 EDT 2020 | dilogic
Since rear feeder bank can be in three different positions, machine must know which one it is. Check in Machine Setup, Parameters - Feeders (see attached image). It that's set wrong, machine will try to reach position out of range and will hit end sw
