Electronics Forum | Sat Jul 07 11:45:26 EDT 2012 | btipcb
I purchased and am setting up a used QSA30. It has been a little frustrating but I finally have an almost program. The isse is that I can not generate a placement program because it says that the ANC is not registered. I can look at it on the sy
Electronics Forum | Thu Jul 30 08:36:29 EDT 2015 | kevinb
I have a K&S 7500 dicing saw with an error code. It reads (F005 system environment is not correct-reinstall system). There is no more support for this machine and I would like to find some help with my problem
Electronics Forum | Mon Jul 09 12:04:56 EDT 2012 | btipcb
After fooling around with it, I was able to clear that error. I didn't know that I had to assign nozzels to each part, I though the feeder assignment would do that. I appreciate the reply.
Electronics Forum | Sun Jul 23 22:01:15 EDT 2006 | smtek_cc
My friend just purchased a MCS30 controller(A) recently, but this controller doesn't have the error code file in the system. If I can find another normal functioning MCS30 controller(B), how can I extract the error file from it(B) and what is the pr
Electronics Forum | Fri Apr 24 13:55:09 EDT 2015 | duchoang
- Clean nozzles. - Clean camera. - Adjust lighting. - Check tolerance level. Good luck.
Electronics Forum | Mon Apr 27 07:01:01 EDT 2015 | leeg
Is it failing due to Vaccuum level?
Electronics Forum | Tue Apr 28 01:09:03 EDT 2015 | leeg
Just check that the Vacuum check is on normal and not set to Special Check.
Electronics Forum | Fri Apr 24 10:58:15 EDT 2015 | chris_jayconsystems_com
I have checked and rechecked all my dimensions on the capacitor which is a 402 size. The manual says that the center is incorrect. Need some help to figure out why it is throwing this part away seeing it passes a vision test. Any help would be gratef
Electronics Forum | Mon Apr 27 11:29:06 EDT 2015 | chris_jayconsystems_com
When I do the adjust to make sure the vision and tolerance is working it works perfectly. But if the machine runs a board I am riddled with this. I have checked the vacuum levels on all the heads and they are within where they are supposed to be for
Electronics Forum | Fri May 15 18:12:30 EDT 2015 | raynewing
I have 2x machines which display this error code. Any help would be greatly appreciated.
.gif)
