Electronics Forum | Wed Apr 11 14:57:31 EDT 2007 | itwasbill
Hi all! We are placing BGA's using a QSV-1 pck and place machine. I believe our profile has the correct information but we continue to get vision results not available when we inspect the part. Our screen appears as follows: NO RESULTS AVAILABLE PAR
Electronics Forum | Fri Jul 19 16:27:38 EDT 2013 | microaide
I think I have the vision problems figured out. There were two problems. 1) The Alignment type was set to "Small" for my TQFP48 part. It should have been set to "Complete". This is a clear case of poor documentation. The AutoProgram manual lists the
Electronics Forum | Thu May 03 22:51:14 EDT 2007 | jmelson
I am still learning the CSM84, but have gotten one board programmed and working. Now, I'm doing the next board, and need to use the mechanical alignment unit for a 22 x 22 mm TQFP. This chip is too large to clear the jaws on any head. Can the CSM h
Electronics Forum | Thu Aug 23 02:31:14 EDT 2012 | fox_su
Hi! We have a dek 265 gsx printer. And we have a problem with it. After determination of fidutials it puts the paste differently. Sometimes it puts senterline, sometimes left of center and right of center. We can't identify the problem. Could you pl
Electronics Forum | Fri Mar 20 02:10:03 EDT 2020 | weglimir
Hi Printer is DEK265GS if I remember correctly. It is definitely not a programing problem, I have 15 different screens which I've checked and all are working fine. It is also not a problem with Y shift, as I've compensated it with CUSTOM SCREEN o
Electronics Forum | Thu Mar 19 03:07:31 EDT 2020 | weglimir
We have DEK265 and a problem with few projects. Normally it works great, but sometimes we have an issue with Alignment out of range error. Currently we have a project where after fiducials configuration in step mode printer shows an error : Align
Electronics Forum | Fri Mar 28 00:13:29 EDT 2014 | jmelson
I was hoping somebody knew how to do this. My method was to place parts at 0 and 180 degree rotation, and adjust head offset until the parts were in the same position at both rotations. Then, I adjusted the M.A. station offset to zero in on correct
Electronics Forum | Thu Sep 09 06:38:35 EDT 1999 | calvin
hi, i m college student. i m currently doing my Final year project in PCB drilling. the main task is to design auto feeder which allign the PCB properly in position before drilling take place. the close tolerance becomes a big problem to the precisio
Electronics Forum | Fri Sep 10 12:09:02 EDT 1999 | Earl Moon
| | | hi, i m college student. i m currently doing my Final year project in PCB drilling. the main task is to design auto feeder which allign the PCB properly in position before drilling take place. the close tolerance becomes a big problem to the pr
Electronics Forum | Sun Sep 12 08:20:04 EDT 1999 | se
| | | | hi, i m college student. i m currently doing my Final year project in PCB drilling. the main task is to design auto feeder which allign the PCB properly in position before drilling take place. the close tolerance becomes a big problem to the