Electronics Forum | Wed Nov 27 18:10:41 EST 2002 | andrewbrook
Quad4C's have their moments. If the price is right and you are aware of the machines limitations then you will be satisfied. The placement rate is slow, 1.2 seconds/chip. Don't buy any Quad if it has the CyberOptics Laser unit, the Quadalign unit is
Electronics Forum | Wed Sep 04 14:12:26 EDT 2019 | bobpan
It sounds like the vac-verify is not working. There is a command on the hht to turn it off. When turning off your hht will show either 'idle' or enter command' without the V showing anymore. Maybe try the cntrl and vacuum or shift and vacuum. If its
Electronics Forum | Thu Sep 05 07:14:16 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the suggestions. Sorry I didn't reply yesterday as I'd gone home - I'm in the UK, so I'm guessing there's a time difference. Okay, I found the control to turn off the vacuum verify - it's SHIFT - SWITCH/VERIFY. Makes no di
Electronics Forum | Wed Sep 04 09:47:41 EDT 2019 | smrsteve
Hello All, I've just bought a Quad 4c pick & place machine. It's so close to actually building boards, but just doesn't quite get there. I was wondering if there's somebody out there with experience of these machines that might be able to help...?
Electronics Forum | Mon Mar 28 10:26:55 EDT 2011 | miroyu
Hello everyone . I received lot of help from people of this forum for which I want to say "thank you" guys. I had problem whit initialization of my Quad 4C which just sits for 2 years after purchase. I manage to locate problem with laser diode on pla
Electronics Forum | Tue Oct 10 11:06:04 EDT 2006 | lheiss
Hi All, I wasn't sure how this would turn out until I ran some production. As I suspected, after every nozzle change the machine dumps the first 3 pickups, checks the nozzle height again (function 30?) and then begins placing with correction with n
Electronics Forum | Wed Sep 04 13:32:22 EDT 2019 | bobpan
Try these things: 1. Do a function 30....your nozzle height should consistently be around 200 +/-20....but whatever number it does find it shouldn't change. (with nozzle on) 2. Most times its the z-bellows....an old z bellows that has a worn out spri
Electronics Forum | Wed Sep 04 13:58:36 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the response. 1. Function 30 gives me a consistent 182-185, even after nozzle changes. I can vary this by changing mod code 15 and I have been advised to aim for 90-110, but it doesn't seem to make any difference so I've go
Electronics Forum | Fri Oct 16 09:48:24 EDT 1998 | Jim Lewis
Help required on vision verify on Quad 4C/Mk2. In component editor, vision verify is OK. When linked into program, the following message occurs: "Bad or missing component description" Machine locks up. Can we get around this? If so how?
Electronics Forum | Wed Nov 16 05:12:36 EST 2011 | bobpan
A couple of things i would try: 1. Does function 30 give you a nozzle height that is repeatable. The number should be around 200.....+/- 20 or so. 2. I would change the z-rod because the spring could be worn out and when the vacuum turns on....it ca