Electronics Forum | Wed Nov 27 18:10:41 EST 2002 | andrewbrook
Quad4C's have their moments. If the price is right and you are aware of the machines limitations then you will be satisfied. The placement rate is slow, 1.2 seconds/chip. Don't buy any Quad if it has the CyberOptics Laser unit, the Quadalign unit is
Electronics Forum | Fri May 18 12:42:50 EDT 2018 | arachid
Hi, i search for drawing of calibration slug to calibrate a vu4/6 vision system on a quad 4c. on my manual it is name spindle runout calibration slug but not have part number. if you can give me this drawing i will very apreciate it. I need picture,
Electronics Forum | Wed Dec 23 22:34:22 EST 2020 | bobpan
Hello Marcelo, When you initialize the system in central controller...does it see mvs? Will a different job that you ran before work or does the same error happen? When do you see this error. You can email me at http://www.precision-repairs.com if y
Electronics Forum | Thu Dec 24 12:43:18 EST 2020 | marcelorotofrance
Hi Bob. When I initialize the system, all functions appears. In "Utilities/Initialize System Comm" option too. I have to confirm yet, but this problem appears to not happen in all programs. The red error message shows when I launch the program. My su
Electronics Forum | Fri Jul 19 16:27:38 EDT 2013 | microaide
I think I have the vision problems figured out. There were two problems. 1) The Alignment type was set to "Small" for my TQFP48 part. It should have been set to "Complete". This is a clear case of poor documentation. The AutoProgram manual lists the
Electronics Forum | Mon Nov 09 15:58:09 EST 2009 | cellis
The biggest thing you will not get is the vision system like this. The 7722 has flying vision for most components and an upward looking vision camera for large components and BGA's. The older Quads had the Quad Align system which is laser vision.
Electronics Forum | Tue Jan 11 13:28:14 EST 2011 | jmw
0603 and up should be no problem on the machine. If you are doing under 25 mil pitch the machine needs an upward camera to repeatably place the parts. You will always lose the first 10 or so parts with cut tape but that should be about it. Repair par
Electronics Forum | Sat Feb 28 01:14:29 EST 1998 | Ray
| | We are facing some placement problems with | | our QUAD 4-C. | | Program was running fine last week, Next week | | program will be off (placement, pickup,vision files | | etc, | | Any help, any idea,??? | | Thanks Glass scales ARE the problem. Th
1 |
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723