Electronics Forum | Mon May 16 17:58:54 EDT 2005 | ??
Are you sure you dont mean quad 100. The software for a quad 1000 (which was a samsung machine) was not available on disks or to install......I dont recall ever seeing it on a disk. If its a quad 100, you would need version cc5.6d central controller
Electronics Forum | Wed Feb 23 15:19:49 EST 2005 | Dilbert
I don't work on quads but I can give you some things to look for... Each of the moving axis work off a motor that is controlled by a "drive". Some of these drives have a fault or error output that is connected to the motion controller. One of your
Electronics Forum | Thu Jan 14 11:10:19 EST 2010 | bobpan
Nice, Now that rings a bell!
Electronics Forum | Wed Jan 13 22:59:53 EST 2010 | goolash
The Central Controller software on our Quad IVc machine is refusing to allow me to add local fiducials. Essentially, I follow the manual's directions, and when I press 'N' for New, it asks me to enter the placement number. No matter what number I e
Electronics Forum | Thu Jan 14 06:27:50 EST 2010 | bobpan
Hello, Havent done them on this machine for 15 years but the manual i have says to go to the teach menu....answer yes/no to local fids taught by autoprogram. If no....enter feeder number and place number then teach. Bob
Electronics Forum | Thu Jan 14 10:07:01 EST 2010 | leemeyer
Placement numbers are 4 digits long, the first digit is the head# followed by a 3 digit placement number. For example if you adding a local fiducial for placement #3 you need to enter 1003.
Electronics Forum | Mon Apr 17 00:18:07 EDT 2017 | teslalab2
The password is QUAD not quad. Not very many DOS programs are case sensitive, CC is an exception....
Electronics Forum | Sat Jan 19 22:42:16 EST 2013 | ngineer
Ok, I managed to figure it out, and this is simply for anyyone having this issue. The issue was that the selected board or board folder did not reside in the selected board directory. the answer was to hold LSHIFT at startup to skip the autoexec of
Electronics Forum | Fri Jan 18 21:13:51 EST 2013 | ngineer
I was trying to set up a new board, and after creating the board directory, the CC spit back a line of garbage and said the directory was invalid. I pressed escape to start over, and it froze. Now when i start it every time, it goes through login a
Electronics Forum | Mon Apr 10 03:06:11 EDT 2017 | arachid
I installed cc 7.54 on dos 6.22, after install the software start and ask me password. when i try to enter the default password "quad" my keyboar not work i cannn't entre any letter. whne i push enter cc says me permission insufisant and close. any c
.png)
.gif)
