Electronics Forum | Wed Nov 27 18:10:41 EST 2002 | andrewbrook
Quad4C's have their moments. If the price is right and you are aware of the machines limitations then you will be satisfied. The placement rate is slow, 1.2 seconds/chip. Don't buy any Quad if it has the CyberOptics Laser unit, the Quadalign unit is
Electronics Forum | Wed Feb 23 15:19:49 EST 2005 | Dilbert
I don't work on quads but I can give you some things to look for... Each of the moving axis work off a motor that is controlled by a "drive". Some of these drives have a fault or error output that is connected to the motion controller. One of your
Electronics Forum | Fri Sep 22 15:35:14 EDT 2006 | lheiss
Hello all, Finally ready to run my first 14 up array and the machine picks up the part moves to the placement location, them moves to home and drops the part. The Z axis never moves. I do get a "run error 1" at about the 4th placement (if it was a
Electronics Forum | Wed Nov 02 04:19:59 EST 2005 | rlackey
There have been times when we could have done with having a Ken or 2; He may not always agree with everyone but he has demonstrated a very good process knowledge over all the time I've been using SMT net. Also I've never read one of his posts that w
Electronics Forum | Fri Jan 30 12:57:19 EST 1998 | Rin Or
| We are facing some placement problems with | our QUAD 4-C. | Program was running fine last week, Next week | program will be off (placement, pickup,vision files | etc, | Any help, any idea,??? | Thanks This could cause by the xy table clamping.May
Electronics Forum | Mon Jan 27 10:06:03 EST 2003 | binns
Just to set the record straight... Samsung did not build all Quad machines. QSA = Quad Samsung America, The QSA-30 machine platforms were manufactured by Samsung, utilizing Quad feeders, other Quad technology and Quad sales and service. Before the
Electronics Forum | Tue Sep 15 13:20:02 EDT 1998 | Jim Mitchell
Quad Systems sells the Samsung product with Quad's patented QuadAlign optics system and Quad feeders as opposed to the mechanical centering system available on the product direct from Samsung. Generally, all optical centering is superior to mechanic
Electronics Forum | Thu Mar 02 04:24:46 EST 2006 | walbone
Hi, We have recently purchased a Quad IVC 115 pick and place machine but are finding it difficult to place SOT23 and similar components. The Visual alignment system rejects the components. We have manually measured and also got the system to measure
Electronics Forum | Wed Feb 25 03:01:13 EST 1998 | MARK EDVINSSON
| We are facing some placement problems with | our QUAD 4-C. | Program was running fine last week, Next week | program will be off (placement, pickup,vision files | etc, | Any help, any idea,??? | Thanks To be honest with you those machine they never
Electronics Forum | Tue May 07 08:35:43 EDT 2019 | paulanderson
I Have a SMTech/Quad MV100 Printer and it powers up and system on activates but does not go through home sequence - any ideas? All axis will move in the diagnostic mode
.gif)
