Electronics Forum | Sat Dec 30 18:49:39 EST 2006 | A.S.
TRY TO REPROGRAM THE AXISES AND CHECK THE WIRES GOING TO THE E-STOP BUTTON THESE PROBLEMS CAN CUASE THESE ERROS TO KEEP COMING UP TRY THIS AND YOU MAY FIX YOUR PROBLEM
Electronics Forum | Sat Jul 07 11:45:26 EDT 2012 | btipcb
I purchased and am setting up a used QSA30. It has been a little frustrating but I finally have an almost program. The isse is that I can not generate a placement program because it says that the ANC is not registered. I can look at it on the sy
Electronics Forum | Mon Oct 09 07:50:22 EDT 2006 | quad
We currently run two Quad IVC's (we are very pleased with them) and two Versatronics for simple small volume batch work. We now need an additional machine capable of placing components at least three times as quickly as a IVC. We don't do anything ve
Electronics Forum | Mon Jul 09 12:04:56 EDT 2012 | btipcb
After fooling around with it, I was able to clear that error. I didn't know that I had to assign nozzels to each part, I though the feeder assignment would do that. I appreciate the reply.
Electronics Forum | Mon Jul 09 18:29:19 EDT 2012 | btipcb
I have gotten to what I hope is the last step before I can start running product. However, I have and keep receiving an "Invalid Place Position X" error in three steps of the placement program. I have verified that the camera can indeed find these
Electronics Forum | Fri Dec 16 12:50:34 EST 2005 | derengmao
I do have all tools for calibrate. The 4" plate is looked like for down-look camera. The big nozzle is for up-look camera. I did all the procedure in the handbook from Traning Center System from Quad. The up-look camera does see the nozzle, and passe
Electronics Forum | Sat Oct 22 14:42:28 EDT 2005 | bobpan
we had a special nozzle made and used the new quad 0402 feeder and the machine didnt miss a part.....but its probably best only to use 1 head to pick the parts because of the z being not 'perfect' between heads and thats where you would have problems
Electronics Forum | Thu Aug 25 07:43:24 EDT 2016 | claudea2
We have been having a recurring error on one of our Quad 4Cs. When it picks up the first of 8 47uF SMT capacitor it stops with a limit error. If we do 2 consecutive function 30s, the problem goes away until the next board. The first function 30 re
Electronics Forum | Mon Jun 12 11:04:20 EDT 2017 | bobpan
So what your telling me is kind of vague. Does the machine home and go to the front left corner of the machine? If it does....this could be a quad align problem....meaning dirt on the lens or so-forth. You should watch the heads homing in the z-axi
Electronics Forum | Fri Feb 01 07:21:32 EST 2019 | dfl
One of my 8mm feeders is blinking the red led after the pick-up. With both buttons the motor works as expected (forward/backward), but after the nozzle pick-up the motor moves forward and then the red led blinks. pressing the buttons the green led l
winsouce.jpg)
.gif)
