Electronics Forum | Mon Sep 10 17:52:30 EDT 2001 | mparker
Are you doing actual measurements of the dummy parts placements? or are you just doing a visual go/no go check? If doing actual measurements, be sure to use mil inch units of measure rather than mm. Mil will give you more accurate readings. mm force
Electronics Forum | Fri Jun 24 09:32:53 EDT 2011 | kahrpr
Looking at the appearance of pads and solder joint is pretty subjective. Especially lead free people are all over the map on the physical appearance of pads and joints. The true test is solderabilty testing, weather it’s just looking for good wetti
Electronics Forum | Fri Feb 09 07:05:57 EST 2007 | ?
300 C Are you a quality engineer?
Electronics Forum | Wed Sep 10 15:28:36 EDT 2008 | slthomas
"I 100% agree that quality engineers can and do solve a lot of problems on the spot." *cough* *snicker* Or did you mean "engineers of high quality"? By and large, the QE's that I've worked with only found, identified, highlighted, or conjured u
Electronics Forum | Tue Jan 30 14:27:50 EST 2007 | Sundaram
I am a Quality Engineer at a CM in VA. Can some one share their knowledge/ process on how to inspect the PCB after application of the solder paste? Also the major issues / defects that we might experience after the application of solder paste on the
Electronics Forum | Fri Oct 17 14:23:48 EDT 2008 | ratsalad
One of our quality engineers established a procedure to use Tarn-X to clean terminals prior to soldering.
Electronics Forum | Fri Dec 30 14:47:44 EST 2022 | dwl
To me, it sounds like a bored quality engineer looking for problems where none exist. I will say that the terminal velocity of a falling reel is below the threshold that would cause damage to typical components. Therefor, it is safe to use a reel th
Electronics Forum | Thu Sep 04 13:09:27 EDT 2008 | realchunks
This is fine from a quality engineers point of veiw, but as you said the vendor never admits to nothing. So the company that has the problem has to resolve the problem for themselves. Generally this turns into a finger being pointed at the process
Electronics Forum | Mon Nov 27 09:17:54 EST 2006 | lrd116
Could anyone please help me in my evaluation of Agilent vs. Omron vs. MIRTech/YESTech AOI? We are a high-mix low-to-mid volume manufacturer looking to gain not just a screening method but real process understanding that a Quality Engineer (myself) w
Electronics Forum | Wed Sep 10 16:09:45 EDT 2008 | vladig
To me it speaks about teh quality of the engineers. I[ve seen both types, though Vlad
winsouce.jpg)
