Electronics Forum | Tue Sep 08 16:18:20 EDT 2009 | proy
We have an Orion which has been running very well. We just started to run production of a board with NO changes from the last run about one month ago. Today, however, the vision system is not recognizing parts. The scan image on the monitor looks goo
Electronics Forum | Thu Jul 28 15:43:48 EDT 2016 | ddina
Recently started setting up our GSM 4681A system, and one of the machines comes up with the message "WAITING FOR OUTPUT BOARD TRANSFER TO COMPLETE" after the Zeroing process has been started. Machine has all the defaults set, two SMEMA connected univ
Electronics Forum | Wed Jul 17 13:54:09 EDT 2002 | kenbliss
Based on the images I do not recongize the logo however it appears you have a pc board with the logo and no name. the pc board did have the UL recognized mark. If you go to Underwriters Laboratories web site http://www.ul.com with the recognized nu
Electronics Forum | Fri May 26 10:59:56 EDT 2006 | James H
I have a panel with 4 boards on it. All boards have the same orientation. Is there a way to set up an offset to make the program more efficient? I also have a few panels with a couple bad boards on them. Is there a way to set up the program to reco
Electronics Forum | Thu Sep 05 22:36:38 EDT 2013 | davef
Yes, providing your: * Inbound material does not compromise your process. * Soldering processes apply the proper amount of flux and activate it properly * Material handling does not contaminate your boards Recognize that the IPC requirements of less
Electronics Forum | Mon Mar 19 19:21:43 EDT 2007 | davef
We picture that the 'ridges' are partitions that run parallel in the box and are spaced wide enough to: * Hold the boards vertical by sliding them into the ridges * Prevent the boards from bumping together Can you rearrange these partitions to form
Electronics Forum | Tue Sep 12 12:43:26 EDT 2017 | deanm
50) traces. The design will be tested for safety and a file will be created listing all the critical components such as transformers, relays, wiring, enclosure material, etc. On the manufacturing side, a manufacturing facility must be indicated in
Electronics Forum | Thu Feb 07 20:55:09 EST 2002 | davef
You are correct about the location of wood on your friendly neighborhood triboelectric scale. But unfortunately for us [and fortunately for the ESD protected material board rack salesperson], the scale does not recognize the effect of the moisture t
Electronics Forum | Tue Feb 12 10:51:46 EST 2002 | stefwitt
Dave is right. There is no machine on the market which can handle a 1.5 m long "board". If you or someone else will have to tinker with a custom made machine, it will be less expensive to use a used machine ( I could be offering some used Siemens mac
Electronics Forum | Wed Jul 19 20:48:05 EDT 2000 | Dave F
Craig: Waving TSOP should be your last choice. You should resist will high levels of red faced, neck vein bulging seriousness. After you loose: * Philips pads are a good starting point. * Recognize you'll probably have to lay-out the pads on the b