Electronics Forum | Mon Jul 04 05:41:24 EDT 2016 | slouis2014
Can anybody advise what temperature can a BGA component on reel be bake and how long.
Electronics Forum | Fri Nov 25 05:16:44 EST 2016 | slavek
Hello, I want to ask on suitable temperature profile for PCBs with ENIG final surface finish. I know that it is complex question with many unknowns. When the PCB will be standard 1,5 mm 35/35 Cu and the amount of components will have any influence o
Electronics Forum | Tue Jun 11 04:08:55 EDT 2019 | aite
What type of product are you talking about in SMT? The SMT05E series are non-isolated DC/DC converters packaged in a surface mount footprintgiving designers a cost effective solution for conversion from a 3.3V to 5V source. Operating Temperature is -
Electronics Forum | Fri Sep 24 11:08:13 EDT 2004 | davef
We're not sure what you mean by temperature sensitive components. From an assembly process stand-point, every component we use is temperature sensitive to one level or another. More specifically, some of our products use polyphenylene sulfide (PPS)
Electronics Forum | Tue Feb 27 07:41:15 EST 2007 | realchunks
Depending on your D.I. system, your maximum temperature concern may be at what temperture it returns to your D.I. system. Hot water may foul you set-up very quickly. As for maximum tempertures for parts, your biggest concern should be drier section
Electronics Forum | Tue Feb 27 10:19:06 EST 2007 | Michael Konrad
If you�re running chemistry in the wash, the wash temperature will be influenced by the chemical manufacturer�s recommendations. Typically, wash chemistries recommend operating temperatures between 130F and 150F. If your application is straight D
Electronics Forum | Mon Feb 26 19:05:32 EST 2007 | KEN
Is there a typical DI cleaner (washer) bath/ spray temperature? (In-line cleaner) Is there a maximum temperature? I know some parts do tend to have issues like TH electrolytic jackets shrinking. But is there any situations to be aware of? Bacteri
Electronics Forum | Wed Sep 03 07:39:19 EDT 2008 | pjc
You may not be getting enough exhaust pull, so the cooling modules over temp. Try swapping blower motors to isolate that before buying one. STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unlo
Electronics Forum | Mon Nov 15 21:32:31 EST 1999 | Dave F
Wolfgang: Sounds like gluteus maximus protection time. 1 "Maximum suitable temperature for the solder joint should be half the liquidous temperature" is a good rule of thumb. Where it came from, I don�t know. One place I�ve seen it repeated is: H
Electronics Forum | Tue Feb 20 15:39:31 EST 2001 | fmonette
To my knowledge, the 40C was established as the maximum "safe temperature" for all tape and reel packaging. The actual specs may vary somewhat for different types of reel, pocket-tape, cover-tape but you must be concerned with the cover tape adhesive
winsouce.jpg)
