Electronics Forum | Mon Nov 13 02:37:36 EST 2017 | slah6678
Recently we facing the Golden finger reject due to contamination with solder after the reflow. Any solution for this kind of reject ?
Electronics Forum | Wed Nov 15 07:21:58 EST 2017 | stephendo
You don't clean contaminated gold fingers so much as you replace them. I once had the "cleaning" solution. It totally dissolved the gold fingers so that they could be replaced.
Electronics Forum | Mon Nov 13 21:31:11 EST 2017 | slah6678
Hi David, thanks for reply We did doing some study, most properly this problem was due to reflow process. Any thing that we can do for the reflow profile ? slow down the ramp up rate or .....
Electronics Forum | Mon Nov 13 13:49:16 EST 2017 | slthomas
Preemptively you can apply Kapton tape to protect the gold fingers during reflow. I think that's what most people do. After the fact, there are services available to clean them up but as it was described in another thread here, it is not in-expensiv
Electronics Forum | Mon Nov 13 21:27:02 EST 2017 | slah6678
Hi, thanks for reply. Kapton tape is costly and it may create another handling issue. BTW can you share the thread for the cleaning process ?
Electronics Forum | Tue Nov 14 15:48:18 EST 2017 | slthomas
Yes, thanks for bringing up that point, DaveF. All polyimide tapes are not created equal, and in my experience Kapton has always worked for this application. The "better deal" has not, ever.
Electronics Forum | Mon Nov 13 14:58:56 EST 2017 | davef
Determine the origin of the solder * Sloppy paste printing technique * Lax stencil underside cleaning practices * Sloppy misprint cleaning practices * Poor part placement practices creating solder balls * Poor material control allowing solder p
Electronics Forum | Tue Nov 14 08:52:07 EST 2017 | davef
If you think the problem is occurring in the box and it is wide spread, consider replacing your solder paste with your paste supplier. There are paste formulations aimed at the solder balling issue that some LF pastes create. On tuning your reflow r
Electronics Forum | Wed Mar 31 21:08:34 EST 2004 | Ed
Hey guys. I've been manually dunking circuit boards for 8 years now. I too have the excess residue issue to contend with. I'm using a low solids - no clean flux from Kester (959). I have used solvents, thinners, windex and a multititude of cleane
Electronics Forum | Wed Oct 24 11:14:44 EDT 2001 | Cemal Basaran
Dave; Thanks for responsding so fast. here are my answers. 1-WOW!!! How do people get these cool toys? I am with the University at Buffalo Electronic Packaging Lab. http://www.packaging.buffalo.edu We have pretty much everything that is sold on the