Electronics Forum | Tue May 21 13:56:05 EDT 2013 | jayjjackson
I'm looking for heater panels ,4500W , 220/440V for our conceptronics reflow oven.
Electronics Forum | Thu Jan 08 11:06:40 EST 2004 | russ
If I read this correctly you have two identical ovens that were setup the same ie zone temps, fan speeds etc... when you ran the same board through each of them one showed a lower board temp. Is this correct? Is the temp of the board 7 deg. lower t
Electronics Forum | Fri Jun 06 15:12:05 EDT 2008 | tomwho
Can anyone give me a contact for someone who sells used vitronic reflow oven parts. I am look for heater panels or heater wire for a vitronics smr-820 reflow oven,or some place that can replace the heater line in them. Thank you
Electronics Forum | Thu Jul 18 13:19:32 EDT 2019 | emeto
Basic rules: 1. The longer the oven the better(if you have the space)- better temp control, better repeatability, better throughput. 2. Only convection - don't get IR heaters 3. Buy reputable brand machine
Electronics Forum | Thu Apr 15 20:41:22 EDT 2004 | Ken
There are ledgitimate reasons for checking furnace calibrations, but let me clarify what that is. 1. TC's are not necessarily calibrted. Not unless you need "absolute" accuracy. TC's operate against a (non-linear) standard +/- a tolerance. Most
Electronics Forum | Fri Apr 16 07:34:10 EDT 2004 | Claude_Couture
Ken, thanks for your answer, it is much better presented than what I was fed by our qc. By "calibrating TCs" I meant the readings the controller is displaying on the screen. So that would be the converter that we would check and calibrate. Thank you
Electronics Forum | Thu Jun 27 03:03:57 EDT 2019 | SMTA-David
Hi, I have a small assembly line that consists of a Semi-Automatic Stencil machine, a Samsung Pick and Place, a small IR reflow oven and a wave soldering machine. The reflow oven is presenting the biggest bottleneck. The machine is a small IR (T960
Electronics Forum | Tue Oct 01 14:53:24 EDT 2013 | felo188
it's means that a pcb part responsible for second top zone is broken. To make sure i changed second thermocouple and heater with first. Now there is no overshoot. But I have still problem with automatically shutdown. It is turning off after 1 or 2
Electronics Forum | Thu Aug 19 12:35:27 EDT 2004 | rlackey
Hi Snehal, Here are some considerations for you: Will you be doing Lead free soldering in the near future? What level of throughput are you looking for - are you high volume, medium or low volume? What is the support network like in your area? W
Electronics Forum | Sun Oct 19 19:01:20 EDT 2003 | harotec
Dave and Pete No bad words against a good batch oven. I don't know the APS-oven mentioned but check out the description of the unique temperature-feedback system in our Ecosold at http://www.reflowsystems.com/press/PressReleases.pdf . As a matter o
