Electronics Forum | Fri Nov 25 05:16:44 EST 2016 | slavek
Hello, I want to ask on suitable temperature profile for PCBs with ENIG final surface finish. I know that it is complex question with many unknowns. When the PCB will be standard 1,5 mm 35/35 Cu and the amount of components will have any influence o
Electronics Forum | Tue Jul 11 12:59:26 EDT 2006 | mattkehoe@sipad.com
We are trying to apply solder to boards with 80 microinches of electro plated hard gold. No components involved, just print 63/37 paste and reflow. The results are very poor on some boards, not so bad on others? Pictures at http://www.sipad.net/thick
Electronics Forum | Tue Jul 28 09:15:49 EDT 1998 | Justin Medernach
| We are about to run our first BGA devices and would appreciate some confirmation on a few points. | First some details: | PCB & Device: | ============= | 1) 16 layer (4 power, 4 gnd, 8 signal) | 2) gold on nickel finish | 3) ceramic BGA with eutec
Electronics Forum | Tue Jul 28 17:23:58 EDT 1998 | Robert Steltman
| | We are about to run our first BGA devices and would appreciate some confirmation on a few points. | | First some details: | | PCB & Device: | | ============= | | 1) 16 layer (4 power, 4 gnd, 8 signal) | | 2) gold on nickel finish | | 3) ceramic
Electronics Forum | Fri Nov 25 20:57:30 EST 2016 | sarason
You guessed right. Not hot enough to get good reflow. regards sarason
Electronics Forum | Thu Oct 11 17:44:30 EDT 2001 | aaelect
OK, OK. 672 ball BGA. The pcbs are PC Card bus size and are .015 thick. There are 3 on a panel with about 1/2" between and rails. The aluminum plates are about 3" by 7". There are 3 cutouts which allow for the parts from either side to protrude du
Electronics Forum | Wed Apr 21 19:59:43 EDT 2004 | Ken
It makes no difference if the solder is in balls, ingots, bars, paste etc. The thermal profile satisfies key areas of the reflow process as a function of your flux and alloy type. Peak and duration above liquiduous are a function of the alloy. pr
Electronics Forum | Wed Apr 21 17:27:27 EDT 2004 | russ
We always use the regular production reflow profile when we use this method. Since you don't want to do that, All that is required is to ramp the part up to temp to get the balls to melt. If you don't exceed 2C per sec. in a ramp you will be fine.
Electronics Forum | Wed Apr 21 11:33:20 EDT 2004 | tigerlordgm
As one of our small batch processes, we place BGAs on PCB without using solder paste. We apply tacky flux to a predetermined height on a pallet, "dip" the BGA into the tacky flux to wet the solder balls to the set height, and then use a BGA rework st
Electronics Forum | Thu Apr 22 18:02:04 EDT 2004 | davef
Could you be looking for this: http://www.assemblymag.com/CDA/ArticleInformation/features/BNP__Features__Item/0,6493,108063,00.html