Electronics Forum | Mon Oct 20 10:28:13 EDT 2003 | Ming Diaz
Hombre, presuming you are doing this as enhancement for looks, I have some comments. 1. LED's seldom run on more than 3 volts. 4.5 volts max for some special types. Because the car is 12 volts all over, you have to use a resistor to reduce the v
Electronics Forum | Mon Jun 08 11:39:28 EDT 1998 | Earl Moon
| How do I mechanically/visually inspect BGA devices when they are soldered to a PCB for possible solder, or other, defects as a first step before part removal and further analysis? I have had board failures due to poor soldering--I think? I can pr
Electronics Forum | Tue Aug 21 21:39:19 EDT 2001 | davef
1) why is No-clean (NC) the preferred process, for BGA mounting by SMT? Probably the same reason NC is the preferred process for mounting non-area array SMT components. 2) why is water-soluble (WS) not a hot choice? There�s not reason not to use
1 |