Electronics Forum | Tue Oct 02 12:56:41 EDT 2001 | Scott B
We have come across this where the operator was using thin gauge solder wire (more suited to fine pitch SMT soldering) to form large solder fillets (power connections or sheild cans). We found that the operator was feeding large amounts of solder wir
Electronics Forum | Sun Sep 30 00:54:06 EDT 2001 | chinaman
Has anybody heard about solder wires for rework with a V-notch in order to avoid solder balls which might be caused by shooting flux when getting hot. The notch is as deep to reach the core so that the flux can expand easily. I can imagine the effect
Electronics Forum | Thu Jul 15 15:55:41 EDT 1999 | nards penalosa
| | We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec d
Electronics Forum | Thu Jul 15 12:26:56 EDT 1999 | Earl Moon
| We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec dwe
Electronics Forum | Thu Jul 15 19:05:58 EDT 1999 | Earl Moon
| | | We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec
Electronics Forum | Thu Jun 22 15:05:55 EDT 2017 | solderingpro
There are several different technologies in the industry today to assist in the out-gassing of flux cores. On automated soldering systems, there are two main types of perforating solder feeders: - Hole Drilling - "V" Scoring By perforating the so
Electronics Forum | Fri Jun 25 12:19:52 EDT 2010 | operator
I have always been under the impression that you want the flux make-up of your cored wire and supplemental flux (squeeze bottle) to be as identical/compatible as possible. I was just looking over a manufacturers datasheet for a resin-based cored wir
Electronics Forum | Tue Jan 19 10:18:58 EST 2021 | grahamcooper22
Hi, try a low spitting cored wire...something like ALMIT SR-LA cored wire...or SR-LA SUPER...it eliminates flux/solder spitting during soldering.
Electronics Forum | Sat Jul 11 03:01:29 EDT 2020 | researchmfg
The bubble inside BGA ball locate at via in pad and apply the resin plug hole.You shall check the cooper plating quality on PCB pad. If there is thin plating or broken on the pad then air will come from the resin plugged via and be trapped inside the
Electronics Forum | Fri Jun 01 17:31:17 EDT 2007 | gsala
Thanks Patrick, also IPC-HDBK-001 explains even better then IPC-J-STD-004, but unfortunately not yet infos about flux for L-F soldering.That's why I am trying to get some infos more from experienced people. Some L-F (SAC or SACX) cored wires vendor
.gif)
