Electronics Forum | Fri Oct 29 23:08:06 EDT 2010 | laen
What software are people using to compute route and retain tabs on panels? I produce some complicated (150 board, 80+ different design) panels, and I haven't found a good way to programmatically compute where to place the tabs. Thanks.
Electronics Forum | Thu Feb 17 15:00:25 EST 2005 | austinj
I am working on fixturing to keep the pcb/panel from "floating" in the oven. The problem is cold solder/non-wetting on all components. My thoughts lean towards the thin pcb not retaining the "preheat temps" for proper soak/reflow. Any thoughts about
Electronics Forum | Wed Jul 05 10:21:39 EDT 2006 | jdengler
Bert, This is a mistake by Fuji (yes they do make some). The fitting is on the table but is blocked by the retainer for the lead screw sleeve. Jerry
Electronics Forum | Fri Jul 21 15:29:20 EDT 2006 | choppy
I've seen something like that on our CP5. The problem was the nut retaining the leadscrew to the bearing (motor side) that became too tight due to an error from the operator.
Electronics Forum | Wed May 16 12:29:57 EDT 2007 | realchunks
Hi Pete, I am familiar with their CM series machine. They have anti static bars inside the machine. If I were you I would measure the board after this machine to see if it retains any ESD. If not I don't think you have a problem.
Electronics Forum | Thu Dec 13 10:35:36 EST 2007 | slthomas
What a preposterous notion. I question your desire to retain your current employment status. This clearly mandates a meeting! Harrrumph!
Electronics Forum | Wed Oct 13 08:37:49 EDT 2010 | denisp
we have a static problem with 0603 led when removing the plastic retainer from the tape and reel. same problem with the feeder causing reject and bad placement. is there someone having the same problem? and how to fix it. thank you
Electronics Forum | Wed Aug 07 08:46:38 EDT 2002 | davef
The time and temperature required for baking moisture from your boards varies according to the conflicting desires to: * Remove enough entrapped moisture. * Desire to retain solderability of solderable surfaces. Search the fine SMTnet archives for s
Electronics Forum | Mon Jan 15 11:07:33 EST 2001 | davef
The new format doesn't bother me. It seems less cluttered. The adverts do seem huge, but the old forum always had that white space on the right side. Maybe we gave up that white space to get bigger ads. It does seem faster. I wish they had retai
Electronics Forum | Mon Dec 06 10:04:53 EST 1999 | Michael Bryant
Bill, Thanks for the tip. There was an error in the printer friendly page for forum postings. We have repaired the formatting problem, so it will retain all of the paragraphs and indents that the original message contains. If you have other observat
