Electronics Forum | Mon Apr 29 05:25:13 EDT 2002 | ianchan
Hi, we do Sn plated I/O pinning insertion into Ni/Au thru' holes. no problems here so far, as we cater for the "interference" (fit-allowances) of the I/O pin into the thru' diameter, via improved PCB thru' hole designs. before this cater/considerati
Electronics Forum | Tue Nov 05 00:53:31 EST 2002 | YNgwie
How do we do press fit component rework ? I have connectors with 700 pins, and the rework part is a headache. What is the best method ? Thanks in advance.
Electronics Forum | Thu Nov 07 04:25:39 EST 2002 | yngwie
What is VHDN connectors ? how to rework thoe package ? cheers...
Electronics Forum | Fri Nov 08 14:53:11 EST 2002 | davef
Cut the sucka off the board and move on.
Electronics Forum | Tue Mar 07 20:33:26 EST 2023 | SMTA-72027903
Hello We have recently started to work with press fit but we are finding problems to reach the specifications in terms of hole deformation and whiskers. Do someone have experience in key process parameters and PCB design specifications (PCB harness,
Electronics Forum | Tue May 28 16:19:52 EDT 2002 | zanolli
Hello Floyd, Yes, special tooling is required. The tooling usually consists of a press, push-in tooling and support plate tooling. The presses can range from relatively simple arbor type presses to automated hydraulic presses with sophisticated con
Electronics Forum | Wed Oct 15 03:59:00 EDT 2014 | rob
Are you using specific tooling for each part, or just generic? If so it could be pushing down at an angle and slightly tearing the PCB. We use the same style press as you but make custom fixtures to fit each connector and hold each PCB tight.
Electronics Forum | Wed Feb 09 12:02:15 EST 2000 | Wolfgang Busko
Sal: If it�s not the PCB, what about the connector itself ? Is it from a different production lot with some unregularities ( dimensions, tolerances, pin alignment, material weakness)? How about handling, storage, shipping causes ? Could it be a tooli
Electronics Forum | Wed Feb 09 10:20:26 EST 2000 | Sal
Currently we have started seeing an issue around a scuzzy connector.The problem being that during insertion of this connnector a couple of pins refused to be inserted and as a result fold over, this folding of the pin is causing the pin itself to fra
Electronics Forum | Mon Jan 12 09:44:00 EST 2015 | rgduval
Oh yeah, I've seen this before! Generally, if the hole sizes are correct (including plating), and the PEMs are within spec, we've found that this is most commonly caused by insufficient support of the PCB during insertion. If you can eliminate supp
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830