Electronics Forum | Thu Oct 04 21:39:44 EDT 2012 | jeffr
Are you saying that the buttons on the Joystick work, but the Joystick lever for XY is not working?
Electronics Forum | Thu Oct 04 17:02:40 EDT 2012 | ekki511
Hallo Jeff thanks a lot for your answer. Yes the error was the bad driverboard. The daughterboard AC . We changed and the mashine is running. Unfortunately we have now a problem with the Handheldkeyboard.The joystick is not working. The same problem
Electronics Forum | Wed Sep 19 06:42:56 EDT 2012 | ekki511
Hello alltogether we have some old assembleon mashines here in hungary. Since some days we are fighting with our Eclipse. After started if we push the ready button appear the error code : L006:Tr.over current. Does anyone know what is Tr. ? Is this
Electronics Forum | Thu Sep 20 21:58:39 EDT 2012 | jeffr
4 connectors because the pins push back ! 2/.. Check mechanical freedom of each axis. With power off.. feel each motor rotation for a burnt armature. 3/.. Replace the Driver Board.
Electronics Forum | Thu Jan 07 18:34:51 EST 2021 | tamcrocker
Hello, I have an UMG VCD-H that is currently stop working due to a message " head Zero switch error" when retracting. I would like to know how to clear this message.
Electronics Forum | Wed Feb 23 13:50:55 EST 2005 | c.b
I am currently using a quad 1000, and up to now it has been a good reliable machine upto yesterday. I now have an error message that reads "driver error, emergency stop" the machine then freezea and will not run. Could some one please tell me if t
Electronics Forum | Tue Nov 13 11:41:23 EST 2012 | dontfeedphils
I can't remember what motor control cards in the machine are interchangeable, but if the controller card for the theta axis is a common control card then you can swap out the one currently controlling the theta axis with a different axis and see if t
Electronics Forum | Mon Apr 08 17:27:36 EDT 2024 | kingkelvin
I found a 0.9mm hex tool - but if I adjust the indicators "all the way up" on the shaft I get all current ranges at 255 (so obviously too high on the shaft) but if I place it anywhere else on the shaft (slightly down from top, or all the way down as
Electronics Forum | Mon Apr 08 15:39:10 EDT 2024 | mistrthou
The error is: MOT-Command/205: Motor speed out of control Motor speed deviates from expected speed. – Problem with power supply, motor current too low. – Mechanical problem, friction too high or tool stuck in Z. I'd be looking at excessive friction
Electronics Forum | Tue Apr 02 14:56:30 EDT 2024 | kingkelvin
Hi all - my problem is a bit worse now - I can get all hydra tests to pass in extended service, except indicator levels at current 7 a bit high past 190 limit at ~210-220 - other than that hydra bank re-installs OK - but still it makes a bad hitting
.gif)