Electronics Forum | Wed Feb 04 05:56:31 EST 2009 | erhard
Hello Bart, we should still have what you need in our museum department. No, seriously we even still repair these units. Please send me your contact details to eh@AdoptSMT.com so we can communicate directly. Best regards, Erhard Hofmann AdoptSMT G
Electronics Forum | Fri Nov 20 03:47:22 EST 2015 | spoiltforchoice
When detected, a PCB with an FTDI FT232 IC will install drivers on the host PC and it will appear as a standard serial port. You can transfer data over it in the same way you would any other serial port,you can also inerface with it using FTDI's own
Electronics Forum | Wed Mar 10 14:05:29 EST 2004 | dougt
The 400E has a computer on the bottom of the cabinet with a a Serial/Keyboard Card installed in it. J1 pins 19/20 are the cutters transmit/receive lines on this card, they go through a transition brd and on to the Cutter/Processor brd on the side do
Electronics Forum | Thu Jul 27 11:27:39 EDT 2006 | gregcr
Hi All, Wondering if anyone is using this Autosplice CC-112 Pin inserter. We have one here and I am wondering if there is offline software or a serial communication spec that is used to load programs in from a PC. We can make changes on the unit i
Electronics Forum | Thu Apr 03 13:20:36 EDT 2008 | rway
We currently build a product that uses RS485. ICT is geared very well at testing serial channels, as long as there is a way to synchronize the transmit and receive lines. But in the case of a simply RS232/485 protocol, simply doing a loopback test
Electronics Forum | Mon Oct 01 19:44:49 EDT 2007 | marcelll
Just bought a used VIP 98 and I have an alarm. Computer don't communicate with the embedded controler of the oven. I've check the cabling, OK, and there's power on the controler. The PC is booting normally. The controler is plug in the serial port 2
Electronics Forum | Fri Mar 05 08:06:39 EST 2010 | rgduval
Rob, Had that issue early on when we hooked up our Heller. For us, the problem turned out to be the serial communications port on the computer. I can't say we had the black screen, but, we had comm errors. I'd check the following: 1. Cable betwe
Electronics Forum | Fri Nov 20 00:16:24 EST 2015 | bwetman
Hyperterminal is a standard Windows assessory located in the "Communications" folder.Here are some steps of data received through the hyperterminal in the PC. (1)Connect your device with your system through RS-232 cable or USB-to-Serial adapter and c
Electronics Forum | Mon Apr 21 23:08:03 EDT 2008 | dman97
Hi, Does anyone know what kind of cable the thinline profiler uses? I recently acquired one of these profilers, but it came with no cables. I went out and bought a female to female serial cable, but it did not work. It will not communicate with my P
Electronics Forum | Sun Sep 25 16:40:09 EDT 2011 | cbroegger
Have been through the same problem with the eurostep cards. The missing communications with the cards, suggest that some acid leaked from the batteries have etched tracks/and or the serial converters (soic8) on the cards. In all cases, clean the card