Electronics Forum | Tue Feb 20 09:46:08 EST 2018 | dekhead
Somewhat vague on error message; obviously has to do with RS Table travel (making sensors at anticipated time) but need to know timing of error incidents and specific error.
Electronics Forum | Tue Nov 13 20:49:08 EST 2007 | davef
Gerber (RS-274-X) - ASCII file with D codes, aperture table included. * .GBX => Gerber (RS-274-X) - ASCII file with D codes, aperture table included.
Electronics Forum | Thu Jun 20 10:23:47 EDT 2019 | key
Would you happen to have a picture of the RS Cylinder and Rs rail. When we send the table in sol 4 is on. When we try to send the table out sol 4 and 5 are on. We are having a hard time finding the RS Cylinder and RS rail
Electronics Forum | Wed Jun 19 18:44:56 EDT 2019 | dekhead
Is the signal making it to the SOL? Is it toggling when signal is present? RS Cylinder is to the rear of the RS rails.
Electronics Forum | Thu Jul 18 13:15:25 EDT 2019 | dekhead
I guess you were able to locate the RS cylinder. Assuming adjustments to RS flow controls was your resolution.
Electronics Forum | Thu Jun 13 20:03:05 EDT 2019 | dekhead
Does it cycle in/out in diagnostics? Have you checked pneumatics to to the RS cylinder?
Electronics Forum | Wed Jun 19 11:26:06 EDT 2019 | key
We have been looking at the Sol for the in and out and the up and down for the blades. We moved the sol around with no change. where is the RS cylinder located in the DEK 248.
Electronics Forum | Thu Jun 27 10:51:59 EDT 2019 | key
Good news we fixed the unit. The air pressure for the RS was not off. made a small adjustment for the in and the out. unit working fine.
Electronics Forum | Sun Dec 26 01:47:43 EST 2010 | twentyninehairs
Do you still have the manual for this? I'm trying to convert one of these into a cnc router. It has a perfect frame for a strong table with a good plenum for vacuum ducting. I'll need to mount a Z-axis to it, probably beef up the y-axis, and re-arran
Electronics Forum | Sun Apr 25 04:34:09 EDT 1999 | Earl Moon
No this message isn't about my triumphant return. It's not even about that lady I wanted to run away with to Mehico (who were you again). It's about progress and some of you might be interested, or not. 1) For DEKheads, I submit we had two of Britai
| 1 |
winsouce.jpg)
