Electronics Forum | Mon Jan 16 09:50:38 EST 2023 | mra
Hi Fern, I'm getting the same error on my CP40 and cannot clear it as well, did you finally find out what to do to solve it? Thanks in advance!
Electronics Forum | Thu Sep 09 13:41:43 EDT 2021 | fernsure
Tried suggested solution in manual to no avail. Reseated every connector we could get to. Has anyone run into this error, and found a solution? This error does not allow me to ignore this head and use the other two. Thanks Fern
Electronics Forum | Wed Nov 22 10:32:46 EST 2017 | itactilum
I need the soft for samsung cp40 lv + i can't find it. reinstall the s.o and I would need the soft. on the other hand it gives me an error that begins to give continuous beeps without stopping and I get the following error message "no sequence fini
Electronics Forum | Sun May 12 01:19:32 EDT 2019 | dunks
I'm in the same boat, fresh install of win 98 and I have multiple versions of the mmi install exe but get these errors. Missing drivers? Is it fixable or lost cause?
Electronics Forum | Mon Jun 11 16:51:32 EDT 2012 | fredc
If the orings are the same as Quad they are .158 ID and .024 thick. These dimensions are in inches. The thread for the Samsung QSA30 is 5.0 X 0.8mm, this may be the same for the CP40. If this is the correct oring size is it special and relatively ha
Electronics Forum | Wed Jun 21 21:28:34 EDT 2017 | maddy
Hi We had same issue with Head 2.if you find solution let me know as well. thanks
Electronics Forum | Thu Jan 24 09:09:46 EST 2019 | protokos
Hi Kathy i had the same issue yesterday and find that a spring is not ok. and i also clean the sensors this was fixing the problem for me.
Electronics Forum | Sat Jun 27 17:49:24 EDT 2020 | jmelson
I can't find much info on the older Essemtec machines. First, I'd want to see the "spec sheet", then I'd want to find out what the programming environment is like. (I was really impressed with the Samsung machines in that regard.) I have not seen
Electronics Forum | Thu Nov 03 02:16:55 EDT 2022 | spacecase
Hey I'm having an issue with a samsung 421f component placer. The machine is fine on the first 5 boards then on the 6th or so it just throws them wherever. The problem is the smallest flat components start sticking to the nozzle even after hitting th
Electronics Forum | Thu May 27 18:41:32 EDT 2021 | bradleycramond
Hi Guys Recently a CP63HP has come on the market near us. (Well 600km away) Unfortunately the machine is not in working order. I have searched the web but can't find much detail on the machine and even spare parts seem limited. Does anyone kno
.gif)
