Electronics Forum | Tue Apr 11 03:01:52 EDT 2017 | tsvetan
check if the top plate which is used for tray change is on it's place, also in manual mode you can see on Sig.IO page all sensors status and you can figure out which sensor is activated
Electronics Forum | Wed Aug 22 14:39:02 EDT 2012 | wendynguyen234
Our S-2000 pick & place machine has head 2 not picking up any nozzle & displays error code 8342(nozzle check error). In ANC setting, head 1 pick/put ok but not head 2; when "MANUAL" box is checked, clicking PICK/PUT then both head 1 & 2's status disp
Electronics Forum | Tue Feb 19 02:03:51 EST 2019 | bukas
try first to replace SYS folder, or one by one of its files. if that doesnt work you are looking at complete disk backup. and check disk for bad sectors ofc
Electronics Forum | Thu Dec 13 10:39:38 EST 2007 | lloyd
Hi Mefunak, I'd say that the vacuum holding circuit is at fault. If the component is picked OK from the feeder ('vacuum check after pickup' is switched on) then the component is being dropped from the head as the gantry moves to the placement positi
Electronics Forum | Thu Dec 13 16:22:15 EST 2007 | mefunak
Thank you,LLOYD,for your response,all your prepositions will be checked. And about switching machine on and off, I absolutely agree with you, it's the perfect cure for Siemens))) But,a strange thing happened,we changed a head,that started to make the
Electronics Forum | Mon Jan 16 19:24:54 EST 2023 | linux
don't have nozzle data for this nozzle. checked with panasonic no data available
Electronics Forum | Wed Nov 14 16:03:08 EST 2018 | cbeneat
Wondering if anyone will have an idea on what we are experiencing with our Panasonic. When the machine goes to change nozzles,it errors out saying "Nozzle exist error(Rack) occurred,(R side)" There is nothing in the nozzle bank, actually replaced ban
Electronics Forum | Thu Jan 12 20:54:30 EST 2023 | cbeneat
When I see that on ours, I take the nozzle off and clean the tip. Any build up and the machine throws that error. Do a set check on the head and then look at the image of the nozzle in question...OR we hit resume and the machine ignores it until the
Electronics Forum | Fri Sep 18 05:10:07 EDT 2015 | bobpan
Hello Simon, I would check to make sure the covers are closed and the cover switches are working. Make sure an e-stop is not pressed. After that....I would check the contactors in the rear of the machine. I have had the contacts on the insides of som
Electronics Forum | Mon Apr 11 15:57:25 EDT 2011 | bobpan
If the feeders that you are having problems with have tall parts in them.....and these are the ones the machine is stopping on.....check to see that you are not scanning higher than what your function 30 nozzle height is. In other words...if your fun
.gif)
winsouce.jpg)