Electronics Forum | Mon Apr 04 09:30:49 EDT 2005 | russ
Andrew, we need a lot more information to help. 1. what is the open caused from? bemt pins, non-wetting, board bowing, or no paste deposited. 2. What is your current stencil design? 3. What does this connector look like and what are the pins? Rus
Electronics Forum | Thu Nov 07 21:28:31 EST 2019 | sssamw
The connector is so long, and has big metal parts, it will be little deformed during reflow I guess, andthe pins planarity should be critical for 200 pins. Did you measure the non wetting pins profile to see if temperature ok? And maybe you can try u
Electronics Forum | Wed May 18 14:58:05 EDT 2005 | splice
Hi, I am having some PTH non wetting issues. Setup and chronology of events is explained: Set Up; Part: 1 MM pitch connector 378 pins Solder: Kester Ultra Pure 63/37 solder Pot; 250 C pre heat; Peak 94C top side Flux: Qualitek 775, Fluxer: foam T
Electronics Forum | Wed Apr 06 22:59:02 EDT 2005 | smt_rookie
It is the solder ball that's usually encountered in a reflow process. It's just that, the paste did not wet well along the connector pins. Before reflow, the paste is actually at the tip of the connector, and stayed there and never went up to fill th
Electronics Forum | Tue Dec 10 22:18:32 EST 2002 | davef
Randy's correct. If you were soldering to nickel with WS609, you would be complaining about non-wetting, not lumpy solder flow.
Electronics Forum | Wed Apr 06 11:54:24 EDT 2005 | Indy
did you try using double header connector pin of a different lot? Indy
Electronics Forum | Wed Apr 06 11:58:02 EDT 2005 | patrickbruneel
Hi SMT Engr With a double-header connector do you mean Double Level Right Angled Header Connector. If so there is a big difference in heat sinking capacity between the two rows, as where the pins of the top connector absorbes twice as much heat as t
Electronics Forum | Wed Apr 06 11:10:47 EDT 2005 | smt_rookie
We process a double-side reflow board (10 ups). Chips and IC's on the bottom side while chips, IC's plus thru-hole connectors and IC sockets on top side (bottom side first then top side reflow). In the past, we were not encountering any soldering pro
Electronics Forum | Wed Apr 06 12:36:53 EDT 2005 | smt_rookie
I've tried a different lot of the same double header connector (yes its double level right angled header conector) twice but nothing has improved. I've also suspected that top row of the connector has greater heat sinking capacity (which should hold
Electronics Forum | Thu Sep 08 06:19:55 EDT 2005 | lupo
Hello, Could anyone provide some support concern issue with vertical fill of through hole solder. Our lead free wave soldering process is not capable to fill 100% (requirement of our customer)through hole. We made everything (DoE) - different amoun