Electronics Forum | Wed May 19 09:32:28 EDT 2004 | Mr Fix it - MPM
Sounds to me like the driver for the tactile is not working. The tactile has three components to it. The first is the switch, the second is the pneumatic up/down actuator and the third is a small motor in the tactile assembly. The motor has a driv
Electronics Forum | Wed Oct 26 05:44:39 EDT 2022 | spacecase
Hello all, I was looking at a Samsung SM421-f component placing machine and it's throwing up an error that was not described in the troubleshooting guide. Anytime I try to move the camera or home it the machine stops and the screen says that a skew e
Electronics Forum | Tue May 04 16:04:40 EDT 2004 | Kuru
Your are right my trackball was the problem, Now it resets and error on Tactile sensor. If anyone knows where I could get used parts beside MPM, please let know. Thanks
Electronics Forum | Thu May 13 16:54:55 EDT 2004 | Kuru
I just installed a used Tactile sensor unit, Now it now reads error "Tactile Sensor sensor never closed". If anyone knows or seen this problem pls help. I have adjusted the flag on the photosensor.The photosensor appear to be functioning but the step
Electronics Forum | Fri May 14 12:40:03 EDT 2004 | Kuru
My switch is good, I can check the switch and the two photo sensors on the input test screen. They are turning on and off.I can see it no the board too. When I start up I can see Tactile unit come down so I know pneumatics portion is good. I am still
Electronics Forum | Wed Jul 23 13:20:24 EDT 2008 | jdumont
Afternoon all, wondering if anyone can suggest a process for the localized removal of silk screen wording from a PCB. I have tried using a scalpel successfully but that it too time consuming and prone to error if an operator were to do it. Obviously
Electronics Forum | Tue Feb 12 14:13:56 EST 2019 | aldrich17
We executed that in IO screen all heads went down, N2323 sensor remained 0. And we cannot find N2223 sensor in the I/O screen. So now we are unsure of the issue but we are searching our manual in the "Placement Head" section hoping to come out with a
Electronics Forum | Mon Mar 16 12:22:58 EDT 2009 | dman97
Here is the screen shot. The program does generate with no errors. This is the only program to give me errors. All others transmit fine.
Electronics Forum | Thu Mar 04 17:56:17 EST 2010 | rmitchell
Hi, When we load a recipe (oven profile) on our heller 1809 the pc screen goes black, the oven turns off then comes back on and the error is communications with oven was lost. Anyone seen this error before? rob
Electronics Forum | Wed May 09 08:48:51 EDT 2012 | leemeyer
Try going into the program definition screen and delete the permanent table top. Then shut down and reboot. The permanent table top will be re created upon reboot.