Electronics Forum | Fri Sep 17 15:43:08 EDT 1999 | Dave F
| HI everyone, | | We are using a Siemens ap-25 screen printer, in the past we have not had any problems with adhesive placement until a couple of weeks ago. It seems the x axis has decided that it should be set somewhere between .00085 and .001
Electronics Forum | Wed Jul 05 17:37:46 EDT 2017 | tobytoby292
I have a UP-100 screen printer that was locking up on me by removing my cursor and not allowing any button presses. I did a hard reset and this fixed it temporarily i now have encountered a new problem where the unit displays a "communication error""
Electronics Forum | Fri Dec 14 19:56:40 EST 2018 | denisss
Good afternoon, the problem gives an error vision gantry x, an error occurs after the camera approaches the car wash and hits the piston, what could be the matter? are there any real specialists gives an error after a certain working time of 40 minut
Electronics Forum | Thu May 15 15:23:08 EDT 2008 | vms
Hello Casper We have a stencil adapter for that machine, we sell a lot of mpm parts. Also know of another one of them you could get for spare parts. Replacement parts are next to impossible for it. Harry
Electronics Forum | Wed Jul 16 10:31:29 EDT 2008 | vms
I would recommend a mpm, some one else would say a dek and some one else would come up with some thing else. Both dek and mpm printers will take the 29x29 stencils. And you have more money than you need for one of them. Shop around and then go and
Electronics Forum | Tue Jan 05 21:28:18 EST 2021 | rmitchell
We have an old MPM accuflex and both camera lights stopped working this morning during production. We tried the bulbs but the new ones did not work either. Any ideas on this? I don't think we have a manual but will keep looking in the dungeon. Plea
Electronics Forum | Thu May 15 15:12:03 EDT 2008 | mgrimes
I have a copy of this manual I could send to you. You can email me at matt@easiky.com.
Electronics Forum | Mon Jan 11 17:19:31 EST 2021 | rmitchell
Problem resolved- The machine camera had crashed when the operator put the PCB in upside down (this was kept secret until intense water boarding). The crash seem to take out a chip on the vision processing PCB. It was visually damaged and looked lik
Electronics Forum | Wed Jan 06 22:10:04 EST 2021 | emeto
Measure if you have power where the light should go. Don't remember but it is probably 5V bulb/12V buld(it should say on it). if you have power, measure the bulb. I am not sure how new you new bulbs are.
Electronics Forum | Thu May 15 09:51:49 EDT 2008 | cbroegger
I have bought an old SP-2400 screen printer, very cheap. I have "repaired" it from my best knowledge, replaced all pneumatic tubes that were in bad shape, replaced some logic in the "controller", and changed it from 110v operation to 220v. Well, to