Electronics Forum | Tue Aug 16 15:39:07 EDT 2011 | mwest
What type of coating is used on the Vitronics selective solder nozzles? Any help?
Electronics Forum | Thu Aug 18 10:37:37 EDT 2011 | tombstonesmt
We do not use a Victronics selective solder but we you activ8 102 stainless steel flux from worton metals for our nozzles. Hope this helps.
Electronics Forum | Mon Nov 10 08:53:23 EST 2014 | jpal
We have the opportunity to buy a new selective solder machine and are used to using a very old Jade machine with a moving tank and wetted nozzle. I have two process concept questions: Which is better- move the board over the nozzle or move the nozz
Electronics Forum | Mon May 01 12:22:09 EDT 2017 | emeto
Pavel, that sounds interesting. Do you know anybody working with this kind of material? I don't even know what the material will be called.
Electronics Forum | Sat Jan 12 11:47:25 EST 2019 | ranap121212
I am looking for a good material for selective nozzle. We are currently using Kovar but it is expensive and wears out it has very good wetting properties.I looking for a material or coating that would allow me to keep the binder flow and with less co
Electronics Forum | Thu Nov 13 12:49:45 EST 2014 | dyoungquist
I have no experience running a "move the board" selective solder so can not compare the 2 methods..... We have been using an RPS Rhythm "move the pot/nozzle" system since 2008. We are using it solder thru hole components onto boards that often have
Electronics Forum | Fri Mar 22 14:19:38 EDT 2019 | gregcr
Thank you ProcEng1 Nordson sent me a flux suggestion list: No Clean: 1. Kester Select 10 2. ALPHA EF-2210 3. AIM FX-16 Water Sol: KESTER 2331-ZX Nozzle Tinning: SUPERIOR #75
Electronics Forum | Mon Nov 10 09:03:47 EST 2014 | rgduval
I can't claim to be an expert....I've just bought a used RPS, and it'll be my first...but, after reading through their manual, and working on setting things up, I'd say: -Conceptually, I like the idea of moving the board rather than moving the entir
Electronics Forum | Fri Jun 23 12:54:53 EDT 2017 | guts1872
We are having issues with top fill and dropping pins on Molex connectors with our KISS 101. Unfortunately we do not have a pre heater and bottom side pre heat with our nozzles is not satisfactory. Most of the issues occur when using a no clean proces
Electronics Forum | Fri Nov 14 10:40:35 EST 2014 | eniac
I use a two machines from EBSO, Germany. It's a machines with PCB carrier, so, solder pot is fixed. I'm fully satisfied with this equipment, but I use only wettable nozzles. If you would like to buy a new machine, not in used condition, EBSO will be