Electronics Forum | Wed May 27 10:26:35 EDT 2015 | jodonoghue
hi a long shot but i am looking for help trying to source a cable from a universal rad 5 sequencer . it is the cable that goes between the interupt sensor and the i/o box .. any help would be appreciated or help on where to look thanks in advance
Electronics Forum | Wed Mar 02 05:02:46 EST 2005 | prabhu_jude
Hello, We are using a film piezo electric sensor to deduct and measure vibrations. A long twisted pair shielded cable is used to connect the sensor to the signal conditioning unit (the signal conditioning unit has to be kept at a distance from the se
Electronics Forum | Wed Mar 02 05:06:15 EST 2005 | prabhu_jude
Hello, We are using a film piezo electric sensor to deduct and measure vibrations. A long twisted pair shielded cable is used to connect the sensor to the signal conditioning unit (the signal conditioning unit has to be kept at a distance from the se
Electronics Forum | Wed Mar 02 13:13:55 EST 2005 | Dilbert
You can contact the manufacturer of the sensor, I don't think they would have anything but they may be able to give you some advice. Can you route the cable a different path away from other cables or objects creating noise?
Electronics Forum | Wed Mar 02 11:00:27 EST 2005 | prabhu_jude
But our requirement is that the conditioning unit has to be kept at a distance from the sensor. Is there any compensation circuit available to reduce the noise effect?
Electronics Forum | Wed Mar 02 09:19:15 EST 2005 | Dilbert
You probably are aware of this, but somehow get the conditioning unit as close to the sensor as you can. It sounds like the problem is the "long twisted pair shielded cable". Try different means of shielding, connect the shield at the end that has
Electronics Forum | Tue Jan 11 16:36:52 EST 2005 | OverTheHill
Update: I replaced the Z sensors in the tool head and the Z sensor cable. Fingers crossed........ I'll keep you all posted. P.S. "Have Fun"? I'm at work, thus not having fun!!!!!
Electronics Forum | Mon Dec 20 10:53:41 EST 2010 | remullis
I started swapping motor cables and sensor cable doing a process of elimination and never found a problem, I put everything back to original and it homed. I not sure if it was a connection issue or it was a sequence of homing the machine needs to do
Electronics Forum | Wed Jan 05 11:26:15 EST 2005 | cyber_wolf
Then Z MOTOR > Then select>CALIBRATE FORCE SENSOR NOTE: you must have a tool in the head when you do this.(Without the tip/spring pushed in) After this calibration the force should drop to 0 when you push in on the spring loaded tip. 2.) Replace th
Electronics Forum | Wed Aug 18 13:48:12 EDT 2021 | rgduval
It's been awhile, but, some other things you might look at: - Check the fiducials on the toolbox. If they're getting obscured/damaged, all kinds of weird things can happen. I had problems initializing tools one time because of this, and I could actu
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
winsouce.jpg)
