Electronics Forum | Thu Apr 28 00:19:52 EDT 2016 | ttheis
I'm not personally familiar with the 265 but it sounds like the machine's board stop actuator is not retracting or a sensor that detects that actuator position is stuck (probably a reed switch.) If your stop is not retracted, then the sensor is telli
Electronics Forum | Thu Feb 14 23:08:41 EST 2013 | dekhead
Squeegee error on a 248 is strictly that sensor (reed SW) on corresponding (Front / rear) squeegee cylinder is not seeing a change in state... Either a physical obstruction preventing cylinder from exending fully - OR- if it is extending fully, then
Electronics Forum | Thu Jan 29 15:57:09 EST 2009 | evtimov
Hi If it is a DC motor just turn the power wires and exchange the sensors. emil
Electronics Forum | Mon Jun 18 09:40:06 EDT 2012 | leemeyer
Does anyone recognize this logo? It is on an optical sensor that I need to repair a wire bonder. Thanks
Electronics Forum | Mon Aug 08 19:09:20 EDT 2005 | bobpan
why not just try to move the sensors and re-wire the motor to run the opposite direction......i wouldnt think thats toooooo difficult?????
Electronics Forum | Thu Apr 03 12:36:30 EDT 2014 | jimmyboz
Hold the F1 key during power up, it will boot into the I/O screen. Check the 3 photo zones. Check the door switch. In the main screen you can cancel D1 or D2, then you can swap light sensors. Check carefully the wiring, there is a SYNC wire betwee
Electronics Forum | Mon Sep 20 22:17:04 EDT 2021 | ttheis
SOLVED Upon manually activating the zaxis to drive the spindles down, it was noted that the touch down sensor for spindle #2 was activating at a certain point in the travel without touching anything. I went to look at the adjustment of the sensor
Electronics Forum | Tue Nov 20 00:15:41 EST 2018 | sabeti
Hi Everybody, We have a dek 265 LT screen printer which unable to detect the plate. I think that it might be the light barrier sensor with the part number of 13pl14. I cannot find a new sensor so I thought I can use a jumper to connect the black wir
Electronics Forum | Wed Apr 08 13:16:56 EDT 2009 | rodrigo
There is a tactile sensor and the air hose and wires do not look like they've been kept up. Is this falling of the Z normal in order to prevent damage to the wires/air hose? Thanks
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723