Electronics Forum | Fri Oct 24 19:27:28 EDT 2014 | wsp364
Do you know the maximum board size for that destacker? I left a message with a sales rep. btw- are you a Torch Lake guy???
Electronics Forum | Tue Oct 21 09:07:35 EDT 2014 | wsp364
My UIC destacker does fine with 2mm thick boards. However, I have to hand feed the 1mm thick boards. I have seen vacuum board placers for small boards but not for large boards. I need to get a solution for 24" x and 16" y boards that are only
Electronics Forum | Fri Oct 24 13:00:36 EDT 2014 | markhoch
I'd check into the ASYS LSB-03 Bareboard Destacker. It isn't a gravity drop style. It uses edge clamps to clamp the top PCB on the stack and then drop it on the transport rail. So it doens't destack from bottom to top, it destacks from top down. We
Electronics Forum | Mon Sep 09 22:05:51 EDT 2013 | mandysmile
Hello, Do you know the MCPCB electronics and Power separation?
Electronics Forum | Fri Jul 28 02:49:24 EDT 2017 | summertang
PCB Separator assemble manual for you
Electronics Forum | Fri Oct 28 06:55:53 EDT 2005 | pavel_murtishev
Hello! I suspect that our MPM AP25 has separation problems (poor stencil � PCB separation). I observe a lot of �dog ears� after print stroke. And this is 100% machine problem, I�m sure. What machine parts should I check first time to avoid separatio
Electronics Forum | Wed Jan 04 10:10:54 EST 2006 | Amol Kane
One of my customer is asking the need for a separate oven for lead-free reflow. In all of my researches in lead-free transition, i have not read anywhere for the necessity of a separate oven for lead-free reflow....am I missing something here?? plea
Electronics Forum | Thu Nov 17 20:23:55 EST 2005 | davef
We're with your customer. We believe inner layer separation is not linked to a heating excursion. What you are seeing is separation between the hole wall and the copper plating in the barrel of the hole on an unstressed PTH. Although, it's possibl
Electronics Forum | Tue Nov 30 12:20:35 EST 1999 | Wolfgang Busko
Hi Steve, is it possible for you to get more than one PCB in a panel and separate them after assembly. Some kind of framepiece for support at the affected edge later to be separated should do it as well. My first ideas Wolfgang
Electronics Forum | Fri Oct 28 06:59:45 EDT 2005 | Rob
From what I remember there is a "snap off" setting in the AP25, where you can set the separation speed & I think it may also vibrate the board a little.