Electronics Forum | Tue Oct 11 19:17:29 EDT 2005 | Dave
Hi Stephen! The nozzle change happens at a much slower speed to what it runs at during pick and place. They are a great machine...when everything works on them ;-) I tried sending through the proper data again and rebooted the machine. A interest
Electronics Forum | Thu Sep 15 18:02:52 EDT 2005 | GAK
If the end sensor is bad it will cause the axis to past it and travel against the end stop and cause an over current also. So it kind of depends on what the machine is trying to do.
Electronics Forum | Fri Oct 02 11:59:37 EDT 1998 | jon Medernach
| I am experiencing solder paste comtaminatin of nozzels on 0603 size components resulting in missing components. The machine is failing to alarm under these circumstances. Has anybody else experienced this problem & found a solution? | Just a sugge
1 |