Electronics Forum | Fri Sep 18 03:02:07 EDT 2015 | linux
Hello everyone. Need urgent help with our cp6, when front door is open servo amp alarm comes up, this error will clear using the reset button. Has anyone any idea how I would go about fixing this issue.
Electronics Forum | Fri Mar 02 18:44:43 EST 2018 | magergar
At boot there is an alarm that I can't get rid off Servo Alarm FRQ AXIS Servo Overflow I tried to calibrate it in mecha mode but the same error doesn't let me, it's there something I can do?
Electronics Forum | Fri Jul 19 12:58:46 EDT 2013 | markhoch
The wonders of Google... Hope this helps. http://www.winsmt.com/down/001.pdf
Electronics Forum | Fri Jul 19 10:45:55 EDT 2013 | kdc45
Have a Fuji IP-2 and the MTU has a servo alarm. There are three servo amp cards and the middle card is showing a 1 on the LED display. Does anyone know what this indicates? Also, can you tell me which axis this card is for? We do not have an advanced
Electronics Forum | Fri Jul 19 13:50:29 EDT 2013 | kdc45
Thanks for the link, however, I have this manual already and it only shows how to replace motors, belts and prox switches and to adjust for zero set. Appreciate your time and efforts. I did find that it is an OC alarm. Thanks again. Regards, kdc45
Electronics Forum | Tue Mar 06 22:35:56 EST 2018 | 3l3ctro
any updates on this?
Electronics Forum | Wed Mar 07 14:55:13 EST 2018 | cyber_wolf
In my experience that error almost always indicates a bad amplifier.
Electronics Forum | Wed Mar 07 19:07:36 EST 2018 | magergar
I have changed the FRQ Amplifier with the FQ amp that has the same parameters and the error persist, the Zero Setting Sensor and the Clutch Origin sensor are working too. Any other posibility?
Electronics Forum | Fri Mar 02 14:00:39 EST 2018 | magergar
I have a problem with my fuji machine, it was working and then this error code appear: INTL SRV creation error Error Code:12037A20 and this shows every time on boot and doesn't let me do anything. what should I check?
Electronics Forum | Thu Mar 25 07:59:57 EDT 2010 | fredc
Hello Rodrigo, My expierence is with metal cutting machine tools not Fuji placement machines. That said there are a several of areas to look at. #1.Interference on your C axis travel, look for scrape marks or something dragging on the drum. #2. Tigh
