Electronics Forum | Fri Sep 25 14:58:33 EDT 2009 | gantry228
It is apparently a Q-series machine, if the adjustment for pitch and roll doesn't work. You may have to loosen or remove the quadalign then check the "wavey" washers to ensure they are there and opposing each other (these provide like a spring effect
Electronics Forum | Fri Sep 25 10:28:08 EDT 2009 | leemeyer
Are you running Q-soft software or is this an older machine running central controller ? Do you have seperate profiles set up for 0603 caps and 0603 resistors or just one profile for all 0603 parts. It sounds to me that you might be scanning to low a
Electronics Forum | Thu Sep 24 17:00:03 EDT 2009 | dogsbody
would any body be able to supply me with infomation on how to adjust a quadalign unit,as a unit on my line will not pick up 0603 resistors,but will pick up thicker 0603 caps. My manuals offer no help.I have run the aligner calibration with the cone t
Electronics Forum | Thu Feb 12 12:22:04 EST 2015 | barryg
Thanks for your input Rob, Our operator does not profile pcb's which so far we have not had issues that could be attributed to his oven settings. We may be running a pcb with a BGA on it and I was concerned about our lack of profiling. I have spent q
Electronics Forum | Wed Aug 13 09:11:19 EDT 2008 | rgduval
Shane, We're assuming that the software is similar to our Heller 1800. We're also assuming that the oven has thermocouple ports, and that you have the thermocouples to plug into them. From the screen that displays the zone data, there should be a
Electronics Forum | Wed May 12 09:59:42 EDT 2004 | gregoryyork
May'be after all these years your eye sight could be failing,other postings including mine asked board type and machine type and set up etc etc. Oh well
Electronics Forum | Wed Aug 13 09:54:41 EDT 2008 | slthomas
+1 on what robgd3 said. It's basically the same process. The bummer is that you only have three thermocouples to give you the information you need, so placement (and attachment) is more critical. You also don't have the predictative capability of
Electronics Forum | Tue Jun 17 01:45:30 EDT 2003 | Dreamsniper
Hi, All these guys have provided you good solid infos already! All I can say is that check your wave solder machine's mechanical set-up too...and the Molten Solder Level in the bath must be maintained at an accurate level/height specially after ded
Electronics Forum | Wed May 12 12:01:11 EDT 2004 | solderpro
Now we are finally breaking the ice, glad to meet you greg, once again did not mean to offend any one and glad to have guys like you on the chemistry end of things... have no problem with the pp file, its mainly set up to help those with issues like
Electronics Forum | Tue Jun 29 13:42:20 EDT 2004 | sigmaprint
You will need to set the contact and squeegee zero calibration every time you set up a new product, we do this because the thickness of the substrate (pcb) can change between product and this will effect these calibration settings. The machine does n
winsouce.jpg)
