Electronics Forum | Mon Dec 20 12:42:15 EST 1999 | Charlie
There is a need to set up the spray fluxer on our wave machine. I'm looking for guidelines and comments form others who have done this set up. Also, is there any rule of thumb at visual inspection when there is too much or not enough flux being appli
Electronics Forum | Wed Feb 27 08:31:02 EST 2013 | anton99
We are a OEM and growing pretty fast. The like the idea of setting up common components on the machine. It makes sense from a set up perspective. All of our set up is off line but the set up usually lasts longer than the SMT run so we have some spora
Electronics Forum | Tue May 22 10:01:19 EDT 2018 | jacson_vu
Hi All, Could you share for me inspection spec that you set up for SPI machine ? Which standard you base that? IPC or something like that. So far, my factory set up as below: Area , volume , high are: lower limit is 60%, upper limit 160% for 0201 ch
Electronics Forum | Wed May 21 00:28:42 EDT 2008 | grayman
Hello, My Friend from USA wants to set up new factory for SMT production (expansion line). Currently, he has production lines in the USA (10 lines with testing). Initially, he will set up 3 lines to produce power supply like AVR and UPS. He doesn't
Electronics Forum | Sun Apr 07 00:45:21 EDT 2019 | d_nguyen2018
Hi, Can you show me how to set up tray table? I have 1 x 10 pockets tape with 10 PQFPs. I went into Magazines then selected Tray Wagon. I did first and last part on the 1 x 10 tape pockets but it did not work. I was told that I must set up the tray
Electronics Forum | Mon Dec 20 17:02:39 EST 1999 | Dave F
Charlie: There's a lot of background setting-up fluxers (including sprayers) in the archives. Chris Shea wrote a paper that's in the library (or where ever SMTnet stores stuff like that) that is pretty good. Good luck. Dave F
Electronics Forum | Mon Sep 08 18:14:00 EDT 2003 | Brian W.
I had an Omni10 that was set up for nitrogen, but also required a water chiller. Make sure your oven wasn't set up to be run with one. If, it was, I know a couple places that sell chillers which will meet the requirements. Brian W.
Electronics Forum | Tue Apr 12 04:35:30 EDT 2005 | dusty
How can I do paste printing and placement set-up without having to waste a panel?
Electronics Forum | Mon Jun 13 02:54:18 EDT 2005 | Adnahn
Is your machine programs gang picking? Work out a machine set-up for commonly used components to have a fix location on the machine ( preferably on the side the operator spends the least time ).Most of your change overs take place on the front of the
Electronics Forum | Thu Dec 13 07:10:38 EST 2007 | realchunks
There may not be an exit cell. Some go by timing. But double check your set-up. Make sure you didn't flag for an exit cell - not sure this is your problem. It also could be your timing. You can simply turn off the the dropped board warning optio