Electronics Forum | Mon Jan 28 13:58:41 EST 2019 | oxygensmd
1. switch the axis cards 2. switch the axis servo cards 3. make sure the distance between scale and encoder is 400um 4. check the signal by oscilloscope, adjust to have the right signal 5. replace the scale or encoder
Electronics Forum | Wed Feb 06 06:14:01 EST 2019 | youngbuck
Try changing conversion board. 2 big ribbon cables plug in to it. p./n 00321189. or the 2 ribbon cables may need to be reseated. Thanks, Ryan
Electronics Forum | Wed Feb 06 07:02:31 EST 2019 | liquidspacie
We've found the problem. It was fault scale encoder. Swapping cards didn't help. Thanks everyone for the input.
Electronics Forum | Mon Jan 28 13:40:53 EST 2019 | liquidspacie
Hello, I'm trying to fix this error and what I've done so far I cleaned (no scratches) measuring scale and swapped cards (gantry 1 & 2) and cleaned scale reader sensor. There are no spare parts, I'm just trding to narrow down the cause. Any suggestio
Electronics Forum | Tue Feb 07 20:43:59 EST 2017 | youngbuck
Does anyone know if there is a way around replacing the entire y axis tape measure scale for one scratch in it ,it can't read.Ive changed reader, y axis servo cards, taxis reader card.Any help would be appreciated.Thank you.
Electronics Forum | Wed Apr 26 05:03:56 EDT 2017 | ariss_t
hi.. try offset the gantry home point.. if cant then.. phewww...
Electronics Forum | Fri Mar 11 09:42:07 EST 2016 | oxygensmd
I am trying to decide how to best dispose of our > old running Siemens equipment. I would like to > get something for them but I am not sure who > needs these older machines I have about 8 > available; any ideas guys? > I am trying to decide ho
Electronics Forum | Fri Feb 15 15:09:24 EST 2008 | soudomphong
Anybody have any idea where to get the cutter motor for siplace 80-S20 with reasonable price? I am also looking for S20 head board, and a Y-axis motor. Any help would be much appreciated, thank you.
Electronics Forum | Thu Jan 29 10:05:28 EST 2009 | soudomphong
I am looking for rolling table z-axis p/n 00320165-02. for rv-d head siemens S20. Anyone know where to get it or have it, please contact me via email seth.oudomphong@variosystems.com Thank you. Seth
Electronics Forum | Wed Nov 03 03:26:38 EST 1999 | Wes
We have Siemens S-20 machine whose other gantry occasionally missmounts all its components in Y-direction(approx. 1/2 mm ). Most of the missmounts happens when there is a lot of 0603 or 0805s (B-side glue boards). Gantry picks up the components OK bu
.gif)
.gif)
