Electronics Forum | Fri Oct 22 23:45:37 EDT 1999 | Jim Cristiano
Hi, I'm looking for vendors that manufacture connector pins that would solder onto the edge of a small SMD pcb so that I can mount it as a SIP onto a larger PCB. Better yet, are there small diameter pins that can be soldered into thru-holes so the SM
Electronics Forum | Sat Oct 23 10:35:54 EDT 1999 | John Thorup
Hi Jim Try NAS Interplex. www.nasinterplex.com John Thorup
Electronics Forum | Sun Aug 25 20:18:32 EDT 2013 | RHL
Contact Akrometrix.com
Electronics Forum | Tue May 21 15:37:36 EDT 2013 | armelinda
I am looking for a service providing non contact PCB flatness measurement for open board SiP assembly. It was returned for failure analysis with complaint that assembly does not solder properly onto customer system board. Since there are remnants o
Electronics Forum | Tue Jun 11 13:44:22 EDT 2013 | 7pcbassembly
Can you provide sample images to understand it in detail? It will give better idea about your explanation. http://www.7pcb.com
Electronics Forum | Fri Aug 30 11:20:17 EDT 2013 | jth
Hi, contact me at joe@zntechnologies.com. ZN Technologies offers warpage measurement at room temp and during reflow using the superior projection moire technique. Best regards, Joe
Electronics Forum | Fri Apr 10 13:25:08 EDT 2009 | jefflkupkt
Layer 2 is the ground plane layer of a 4 layer board. After installing a 2.5 mm DC power jack and 0.1 center SIP header by hand, the ground pin disconnects and causes an open. My board supplier said they passed Electrical Test. Prepreg was within
Electronics Forum | Tue Apr 29 11:18:16 EDT 2008 | julienvittu
basically your problems come from the copper balance top and bottom side we are using substrate down to 0.18mm (semiconductor industry/ Bga package / SIp business) you have to respect 5% difference maximum between Top and bottom side otherwise you
Electronics Forum | Thu Jul 20 15:37:53 EDT 2000 | Tekguy2000
These parts are flat chip resistor arrays that have 4 end terminations on each side. It looks liek an IC but is typically in an 0805 and 1206 package type with convex terminations. .031" pitch from termination to termination and .011" spacing between
