Electronics Forum | Mon Oct 21 03:27:15 EDT 2019 | btkhoo68
we would like to monitor ASM siplace feeder, cycle time, nozzle.event using SCADA. Anybody able to provide memory address allocation for above data value to read by SCADA
Electronics Forum | Thu Jan 07 03:32:19 EST 2021 | ravikumargv
Dear All, In S27HM siplace machine PCB camera images not display and when i try to teach feeder potion or fiducial position PCB camera light is glowing but, images not showing in monitor, kindly help what is the root cause for this issues... Regard
Electronics Forum | Sat Oct 10 08:12:50 EDT 1998 | Rick I.
we currently have a siplace line(80s/f) and are inhereting a fuji line from another site. I need an objective comparison between the two. What are the strengths and weaknesses of the fuji with regard to programming, operating and maintenance. any cav
Electronics Forum | Fri Jun 12 01:17:52 EDT 1998 | Erhard
Are you using extra feeder tables that you can setup off line and than just exchange for the ones you had in the machines for the previous batch? This way the Siplace should not be too bad. Otherwise for fast change and low volume you might look at m
Electronics Forum | Fri Jun 12 15:06:45 EDT 1998 | Marcos Silva
| You can prepare your setup off line, using additional tables, and exchange very fast just sending the new program and checking using a barcode reader. Also you can edit a setup program with mixed feeders between PCB families. You can decrease your
Electronics Forum | Fri Jun 12 11:54:55 EDT 1998 | Rin Or
| I am currently in the process of trying to justify new equipment in my factory. I currently have Siemens siplace 15 series machines. I don't feel thins equipment is right for high mix/ medium to low Volume. I am running up against a in house con
Electronics Forum | Tue Mar 12 22:40:43 EST 2002 | davef
Shoot a note to Stefan at http://www.steering-inc.com Check out his manual Siplace for dummies
Electronics Forum | Wed Jul 19 12:25:47 EDT 2006 | Rob.
Hi Fabione, I'm not being funny, but how did you come up with that choice of machines? There is no way that these set ups are equal in speed or accuracy in the real world. I think you should go back to the drawing board & start again, and depending
Electronics Forum | Thu Jul 20 11:28:40 EDT 2006 | Rob
Mydata are OK, but they will not last as long as the Siplace if running the same volume. They are easy to programme, change over & upgrade - they are very good entry level machines. One thing to remember is that they make use of large scale gang pi
Electronics Forum | Fri Oct 08 06:54:04 EDT 2010 | plruzza
My factory is in front of establishing SMT production line. I have difficult task to select what machines we will buy. Unfortunatelly I don't have enough experience because so far we had through holes production only. On the market exist many produce
winsouce.jpg)
.gif)
