Electronics Forum | Thu Oct 23 17:59:44 EDT 2003 | Jim
Where can I find information on how to setup a prewave slide line and automated tools to calculate the workload balance? Regards
Electronics Forum | Tue Nov 09 10:44:29 EST 2004 | stefwitt
If you are doing small circuits, you could use glass slides http://www.hometrainingtools.com/catalog/microscopes-accessories/cat_microscope-slides.html apply conductive epoxy traces, place your components in it and cure at ~ 120 Degree C
Electronics Forum | Mon Jan 07 08:50:12 EST 2008 | quaker332007
Can anyone help me out. I'm trying to find a MTM Standard Booklet to get a recommended number of parts that one operator should populate at one time. During the slide line operation thanks
Electronics Forum | Tue May 15 14:23:20 EDT 2001 | medernach
Again, I'm not familiar with your material but SMT Adhesives as a collective group are typically hydroscopic. An increase in humidity in your facility will lower the viscosity of certain materials. I don't want to say who's material I've had bad ex
Electronics Forum | Mon Jan 07 09:25:55 EST 2008 | pjc
One per operator is the optimum for obvious. 3 to 4 per operator is more typical. The number is not as important as the type and time. Like don't have someone handle 2 different TO92 part nrs., splitting them up to different operators eliminates the
Electronics Forum | Wed Apr 08 18:47:57 EDT 2009 | swag
Could be the z-axis driver card???
Electronics Forum | Mon Apr 13 16:06:36 EDT 2009 | soudomphong
I thought AP-25 was old. Good luck!
Electronics Forum | Thu Aug 13 16:25:11 EDT 2015 | emeto
Loctite 3609. Just a small dot under the D-Pak and it works 100%.
Electronics Forum | Mon Aug 28 17:28:16 EDT 2017 | dekhead
Edge connector attaching to gold fingers?
Electronics Forum | Tue Jul 09 15:55:36 EDT 2019 | alpha1
Have you checked the bearing on the linear slide bearing on the CTA?
winsouce.jpg)
