Electronics Forum | Wed Mar 11 15:39:34 EST 1998 | ETS
For Sale: Full convection reflow oven, slightly used. 5 zone, 100" heated length, 200" overall. 40" cooling zone, edge rail conveyor, built in profiler. For information contact Brian Stumm @ 509-483-0900 or by e-mail.
Electronics Forum | Thu Jul 01 14:44:40 EDT 2004 | Mark
The service has slightly gone downhill since the last layoff they had. But I have had no problems and seem to get all the answers I need. The reason for slightly downhill is they don't have many left to answer calls, answer emails, and do service run
Electronics Forum | Sun Jun 16 05:23:28 EDT 2024 | ushir
Hi guys Our Koh Young SPI 8030-2 seems to be slightly out of calibration where the camera is out of focus slightly. Does anyone know what the calibration procedure is? Thanks
Electronics Forum | Fri Feb 15 13:37:31 EST 2002 | gtemple
What about reducing your force and slow the blades down slightly
Electronics Forum | Thu Feb 08 08:33:08 EST 2007 | jdumont
Most likely ground plane stealing your heat. Increase dwell slightly if you can.
Electronics Forum | Mon Apr 02 10:23:38 EDT 2007 | realchunks
The parameters are the same as leaded paste. The results are slightly worse.
Electronics Forum | Fri Feb 15 18:51:13 EST 2013 | hegemon
My hat in the ring too, but with ALL pads showing 95% coverage or better. Slightly different interpretation! 'hege
Electronics Forum | Fri Nov 06 11:56:43 EST 2015 | derrikf
They're probably 12 - 18 inches, maybe slightly longer.
Electronics Forum | Mon Nov 11 21:19:06 EST 2019 | dekhead
Knead pressure, is normally at or slightly lower (maybe 25%) than print pressure...
Electronics Forum | Thu Jul 30 10:03:53 EDT 2020 | philc
If the PCB is thin, is it possible that the board is warping slightly during the curing process?
