Electronics Forum | Sun Jul 10 09:11:59 EDT 2005 | davef
What does Cookson [ http://www.scscookson.com/parylene_equipment/testing-ionograph.cfm ] say?
Electronics Forum | Fri Jun 14 13:47:21 EDT 2013 | rway
Chances are this is not a component failure. First, these are passive components with passive testing on the ICT. He may have guarding issues, but more information is required as has been stated. Are all capacitors with the same P/N failing in dif
Electronics Forum | Fri Jun 14 12:00:10 EDT 2013 | rgduval
Is this a new assembly/new test fixture/program? Or is this an existing assembly that is suddenly exhibiting this failure? Capacitors measured in circuit will not necessarily measure their correct values. Active components in circuit will be affec
Electronics Forum | Fri Mar 19 03:13:35 EDT 2010 | mun4o
Hi, First check what the Moisture Sensitivity > Level of the LEDS is....you may need to ask the > LED manufacturer. Once you've established it is > moisture sensitive then follow latest version of > IPC JEDEC 33 spec. for storage of them and dryi
Electronics Forum | Mon Mar 22 10:24:14 EDT 2010 | mun4o
Hi , I think that our problem is humidity, because when I use leds from new tape ( pack in MBB ) no any defects.After that, we put opened tape in our store.After 2-3 weeks I use the same tape with leds, and we have 2-3% defective leds.I make this tes
Electronics Forum | Tue Mar 23 03:42:51 EDT 2010 | grahamcooper22
Hi, It is very important to follow IPC JEDEC 33 specification for storage and handing of all MSDs. In many instances defects caused by excess moisture in packages is not immediately evident (pcbs may pass final test) but when pcb has been in the fiel
Electronics Forum | Tue Jun 18 03:16:46 EDT 2013 | mun4o
production lot is 4000pcs.About 70% of capacitors are out of tolerance ( +/-20%).There are 3pcs C=10u per PCB, in different location.Samsung capacitors wich we use are 1,5 years old - i checked this information from our supplier " Rutronik ".I have
Electronics Forum | Tue Jul 18 16:40:09 EDT 2006 | dphilbrick
We have a system where when we set up the line to run a job before the first part is placed an auditor verifies we have all the correct parts loaded on the machines in thier correct locations. We then run a first article. The board is inspected to in
Electronics Forum | Fri Jun 14 13:43:02 EDT 2013 | rway
The low value will be 0.624uF. You have to factor it from the low tolerance (-10%). So: 0.9 x 0.92 (machine tolerance) x 0.91 x 0.91 x 0.91 (3 decade aging factor for X7R dielectric). We factor hours at the 3rd decade (10,000 hours), but you can
Electronics Forum | Tue Jun 18 09:51:53 EDT 2013 | rway
If they're 1 1/2 years old, they are definitely aged parts. Either send them back for newer or widen your tolerances on the ICT to compensate. You are at the 3rd decade now (10,000 hours) and you will need to compensate for this. These parts are n
winsouce.jpg)