Electronics Forum | Fri Dec 08 14:35:28 EST 2006 | glynnhamer
We currently are building a pcb that has gold fingers, about 36 in a concave V overall shape from .275 on the outside edge fingers tapering down to .197 in the middle of the 2 inch span that plugs into a shelf connector. These fingers are on both sid
Electronics Forum | Sat Dec 09 08:32:25 EST 2006 | davef
Thoughts are: * Most board fabs have routers that can do this work. Can yours rework these boards? * Scrap the boards and start anew. Someone made a mistake. Cut your losses. * As a wild and crazy guy alternative, buy a router with a 45* bit from
Electronics Forum | Mon Mar 22 07:40:01 EDT 2010 | emanuel
Are you absolutely sure the problem is with the humidity? We had a problem with 3528 size leds, damaged by the pick and place nozzle because a 0.2mm mistake in the height measurement. Also, we found that several suppliers are using fake desiccant ba
Electronics Forum | Tue Jan 22 18:53:37 EST 2002 | barry
Hi all, or anyone. We recently purchased some smd equip. to do our own inhouse assy. Though we did purchase a training package it was short and sweet. What I was wonderin is their any tips on oven profiling, we were told that 90% of our product would
Electronics Forum | Tue Aug 24 20:12:12 EDT 2010 | davef
What is a "SMD push fit connector?"
Electronics Forum | Tue Aug 17 04:43:57 EDT 2010 | aj
Hi all, Just looking for some advice on SMD push fit connectors. Are most machines spec'd do place these reliably or do they cause problems? AJ...
Electronics Forum | Wed Jun 27 14:36:22 EDT 2012 | cyber_wolf
If the X axis is moving then maybe your Elmo is not adjusted correctly. There is a procedure to adjust it in the manual(assuming you have the original manual). The correct location is XGTS which is a white connector on the booster. The fans are 24V
Electronics Forum | Wed Jun 27 13:38:56 EDT 2012 | upguy
Thanks for the information and insights. Our booster is probably getting too hot, even with AC. There is bouncing when we trim component locations. Every so often, while trimming component locations, the x-axis will start to slowly move away (by i
Electronics Forum | Tue Jul 17 10:47:54 EDT 2012 | upguy
As as per your information and photo, we attached two box fans under our booster and attached them to the white XGTS connector. The fans are blowing upward with airflow between the booster board and the back of the machine. We will carefully watch
Electronics Forum | Wed Jan 05 12:33:01 EST 2000 | Vahid Vatannia
Thanks for the info. I am going to call AMP and ASG. Thanks again.
