Electronics Forum | Thu Sep 02 21:02:55 EDT 1999 | Paul Wareham
We've noticed that there are many different recommendations for pad sizes for various SMT parts. This seems to vary wildly from manufacturer to manufacturer for the same case sizes. Is there any standards that can used used to specify these sizes?
Electronics Forum | Wed May 09 10:40:10 EDT 2001 | davef
First, your primary side component pads should be designed according to SM-782A, "Surface Mount design & Land Pattern Standard". Next if you did that and your secondary side component pads are the same size as your primary side components, your diff
Electronics Forum | Sun Sep 05 03:52:11 EDT 1999 | Brian
| We've noticed that there are many different recommendations for pad sizes for various SMT parts. This seems to vary wildly from manufacturer to manufacturer for the same case sizes. Is there any standards that can used used to specify these sizes
Electronics Forum | Tue Sep 07 09:11:33 EDT 1999 | Dave F
| We've noticed that there are many different recommendations for pad sizes for various SMT parts. This seems to vary wildly from manufacturer to manufacturer for the same case sizes. Is there any standards that can used used to specify these sizes
Electronics Forum | Fri Sep 03 03:56:41 EDT 1999 | Wolfgang Busko
| We've noticed that there are many different recommendations for pad sizes for various SMT parts. This seems to vary wildly from manufacturer to manufacturer for the same case sizes. Is there any standards that can used used to specify these sizes
Electronics Forum | Fri Sep 03 14:37:45 EDT 1999 | JohnW
| | We've noticed that there are many different recommendations for pad sizes for various SMT parts. This seems to vary wildly from manufacturer to manufacturer for the same case sizes. Is there any standards that can used used to specify these siz
Electronics Forum | Mon Sep 06 19:59:59 EDT 1999 | armin
| | | We've noticed that there are many different recommendations for pad sizes for various SMT parts. This seems to vary wildly from manufacturer to manufacturer for the same case sizes. Is there any standards that can used used to specify these s
Electronics Forum | Wed May 09 01:23:17 EDT 2001 | GregH
Hi, My Bottomside component pads are 1:1 with my topside land sizes/dimensions. I have difficulties catching solders on my bottomside smd chips (SMB Diodes, 0805 RC Chips). What should the bottomside components for wave soldering be greater than my t
Electronics Forum | Fri Jun 06 13:03:01 EDT 2014 | asksmt
Hi All, i have footprint 2X5 RA HEADER 2MM spacing in design. I am using about 9 mils of annular ring on top side and about 12 mils of annular ring on bottom side. refer picture attached. we are having solder short issues during wave solder so was
Electronics Forum | Thu Apr 26 18:39:45 EDT 2001 | jagman
I'm looking for information (links) to pad design and layout spec's for different sized passive SMD's. To be specific, 0603, 0805, 1206 and 3216 sized parts. I'm most interested in finding out about land spacing between two parts. What is accepabl