Electronics Forum | Fri Oct 16 12:45:23 EDT 1998 | smd
| | | I need to install some new lines for high mix low volume products in an already cramp building. Could someone share any info about the machines which give you the best bang for floor space. I need a 2 machine system for placing 0402 to fine pi
Electronics Forum | Thu Nov 30 11:10:36 EST 2000 | DL
Can anyone point me in the direction of where to find some lead placement equipment. Currently we have Clip leads that come in reels with solder pre attached are currently done by hand. surface mountable leads/connectors will not do, due to board/end
Electronics Forum | Thu Nov 30 21:35:57 EST 2000 | Dave F
So, what's a clip lead? We've got two technologies 1 Surface mount 2 Pin through hole Major categories of pin through hole leads are: * Axial Lead Components have all of its lead wires extending from a component or module body along its long axis.
Electronics Forum | Thu Nov 30 23:48:16 EST 2000 | DL
Dave, Thanks for the input. I cant beleive I didnt think to check the suppliers web site, I feel like an... well anyhow. The leads I'm referring to are place at a 90 degree angle from the edge of the pcb and extend towards the bottom as opposed to
Electronics Forum | Fri Jul 24 12:12:52 EDT 1998 | smd
200 boards/Hr and oven will reflow ~180 boards/Hr but the P&P machine will only place 700-950 CPH | | when setup is taken into account. Minimum pitch is normally .020" and we place an Avg. of 491 TSSOPs and 217 BGAs a month. | | We don't even bother
Electronics Forum | Wed Jul 15 10:37:58 EDT 1998 | Ben Salisbury
| | We just have a use cp4 .I have a problem on transfering data between cp3 to cp4 .when I use the data for cp4 I can't have parts in correct location. Is that normal? or it's because that has a different vision system.if so.how can i do with it.the
Electronics Forum | Wed Jul 15 06:32:03 EDT 1998 | Process Engineer
| We just have a use cp4 .I have a problem on transfering data between cp3 to cp4 .when I use the data for cp4 I can't have parts in correct location. Is that normal? or it's because that has a different vision system.if so.how can i do with it.the d
Electronics Forum | Fri Mar 19 03:50:37 EDT 2010 | grahamcooper22
Some things you have to be sure of... Can you guarantee the LEDS are DRY when you receive them ? They may be packed in dry bags but when was this done and has the LED distributor had them open at his site ? Using vacuum sealed dry packs is a good way
Electronics Forum | Fri Jul 08 12:54:02 EDT 2005 | Roberto Rodriguez
I have a omega meter 600 SMD, but I need a calibration Certificated and Service Support, I'm tring to find in Internet but this machine is OLD. Do you know a company give this Service? Please contact to Email. Roberto.Rodriguez@Teradyne.com Eng. Ro
Electronics Forum | Tue Jul 18 16:40:09 EDT 2006 | dphilbrick
We have a system where when we set up the line to run a job before the first part is placed an auditor verifies we have all the correct parts loaded on the machines in thier correct locations. We then run a first article. The board is inspected to in
winsouce.jpg)