Electronics Forum | Wed Jul 12 17:17:04 EDT 2006 | fordf1502004
I want to thank you for your help. after further investigation into the panasonic machine one our technicians was able to fix the issue. The panasonic machine uses a 5 volt signal and normal smema uses a 24 volt signal. To make these 2 machine talk t
Electronics Forum | Wed Jul 12 16:17:33 EDT 2006 | nodlac
FYI Here is the SMEMA Link for the generic interface configuration. http://www.smema.org/smemastandards.htm and http://www.smema.org/smema1.2.pdf These Doc should give you the SMEMA pin outs. Cal
Electronics Forum | Wed Sep 07 16:36:18 EDT 2016 | ttheis
It does look like it was setup for fuji or siemens connection. I did get the smema signals working; had to add the connections for pins 3 & 4 on both ports and move some of the existing connections according to the smema diagram. Also, I wasn't seein
Electronics Forum | Wed Sep 07 07:53:16 EDT 2016 | ttheis
Looks like I've got to reconfigure the fmi connections. Only pins 1 & 2 populated and when I jump the fownline pins the upline ready signal is activated. I'll reference the diagram and setup the connections for smema.
Electronics Forum | Fri Apr 01 07:38:52 EST 2005 | bobpan
The machine has 2 25 pin cables that are supplied with it and you have to have adapters that plug into them for smema or siemens. The cables are x20 and x21 smema pigtails.
Electronics Forum | Mon Aug 23 20:06:49 EDT 1999 | Peter
I am looking for a source of tooling pins (various diameters) which can be easily attached (ie. taped) to pieces of FR-4 stock to allow for quick and cheap fixtures to run in my smt machines. I've seen these in the past where the pins are attached t
Electronics Forum | Mon Aug 23 20:56:29 EDT 1999 | Dave F
| I am looking for a source of tooling pins (various diameters) which can be easily attached (ie. taped) to pieces of FR-4 stock to allow for quick and cheap fixtures to run in my smt machines. I've seen these in the past where the pins are attached
Electronics Forum | Tue Aug 24 15:06:06 EDT 1999 | John Thorup
| | I am looking for a source of tooling pins (various diameters) which can be easily attached (ie. taped) to pieces of FR-4 stock to allow for quick and cheap fixtures to run in my smt machines. I've seen these in the past where the pins are attach
Electronics Forum | Wed Sep 23 00:06:34 EDT 2020 | SMTA-64387098
I have modules that come with a 4 x 2 pin header. The problem is the pins must be oxidized as they do not take solder (no wetting occurring). This occurs whether solder in our wave soldering machine or soldered by hand. I tried cleaning the module i
Electronics Forum | Mon May 01 12:32:50 EDT 2017 | emeto
Looks like you have bad wetting. I will do in this order as it is easier to troubleshoot starting with the machine and transitioning to the PCB: 1. First clean some bare PCBs really good and try again. 2. Check thermal profile 3. Check flux - amount
